4iiii Innovations V100 ZZNV100 ATHLETIC HEART RATE MONITOR ANT AND BTLE User Manual
4iiii Innovations Inc. ZZNV100 ATHLETIC HEART RATE MONITOR ANT AND BTLE
User Manual
4iiii Innovations Inc 228 River Ave. Cochrane, Alberta Canada T4C 2C1 800.218.3095 Fax 403.800.3097 www.4iiii.com
Viiiiva User Manual
Instructions for Use
What’s in the Box:
How to Use
Wet the electrodes (the smooth rubber-like surfaces located at either end of the
elastic strap).
Undo one snap and wrap the strap around your chest.
Wear the monitor centered at your breastbone with the logo right side up.
Adjust the strap for a snug, comfortable fit.
Viiiiva will automatically turn on when worn (and automatically turn off a few minutes
after removal).
Pairing with ANT+ Displays (such as Garmin/Timex/Adidas watch/computer)
Your Viiiiva heart rate monitor has a unique device ID that allows it to be paired to a
ANT+ display device. Please refer to the display device’s instructions for pairing, as
these operations are unique to each device.
Pairing with Bluetooth Smart Display (such as iPhone/iPod)
Your Viiiiva heart rate monitor has a unique device ID that allows it to be paired to a
Bluetooth Smart display device. Please refer to the display device’s instructions for
pairing, as these operations are unique to each device.
Pairing with ANT+ Sensors (such as foot pod, bike speed/cadence, power meters)
The Liiiink Communication Module in Viiiiva acts as a bridge so that your ANT+ sensor
data can be transmitted to Bluetooth Smart devices. After Viiiiva is paired with a
Bluetooth Smart device, refer to your app instructions for pairing to Bluetooth sensors.
Maintenance and Care
Replacing the Battery: Use a coin to remove the cover on the back of the heart rate
monitor to reveal the battery (CR2032). Be careful not to damage rubber seal when
reassembling.
Cleaning: For best results, rinse strap with water after each use, and hand wash
strap in cold water with a mild detergent after every 6 uses. Do not put monitor or
strap in the washer or dryer.
V100 Heart Rate Monitor
with soft elastic strap
4iiii Innovations Inc 228 River Ave. Cochrane, Alberta Canada T4C 2C1 800.218.3095 Fax 403.800.3097 www.4iiii.com
Viiiiva User Manual
Regulatory Compliance
FCC Compliance Statement
FCC ID: ZZNV100
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
15.21
Any changes or modifications of this product, not approved by manufacturer will void the
user’s authority to operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Industry Canada Compliance Statement
IC: 9896A-V100
This device complies with Industry Canada licence-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.”
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.