A and D Co AD1321-10MW Wireless Module User Manual
A&D; Co Ltd Wireless Module
User manual
6 AD1321-10MW ZigBee Module Manual
A&D Company,Limited
1, OUTLOOK
This model is the general-purpose ZigBee module using the ISM band of the 2.4GHz zone at 10mW. It
has an outside antenna terminal. You can control the module by an AT command and send data in a
protocol of SPI (CSI) of the serial communication.
2, CAUTION & NOTICE
FCC CAUTION
z Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
FCC NOTICE
z FCC compliance statements are required to be included in the user manual of final
system.
z This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received,
including interference that may cause undesired operation.
z This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
z This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
z This equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and
meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65. This equipment
has very low levels of RF energy that it is deemed to comply without testing of specific absorption
ratio (SAR).
z When you use this module in your products, Please specify as follow sentence to your product.
[Contains Transmitter Module FCC ID:KSNAD1321-10MW]
Or [Contains FCC ID:KSNAD1321-10MW]