AAMP of Florida AAMP Global BC BluClik Bluetooth remote control User Manual

Download:
Mirror Download [FCC.gov]
Document ID	2248426
Application ID	7PMZiFR+lITJipyo3EREQg==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	42.71kB (533838 bits)
Date Submitted	2014-04-22 00:00:00
Date Available	2014-04-23 00:00:00
Creation Date	2014-03-14 16:19:16
Producing Software	Adobe PDF Library 9.9
Document Lastmod	2014-04-16 01:02:34
Document Title	Users Manual
Document Creator	Adobe InDesign CS5 (7.0)

BluClikTM
Wireless Remote Control for Bluetooth Devices
Initial Pairing (begin here)
1) Flip switch on the rear of the remote to “i” for iPod, iPhone, or iPad or “A” for Android.
Note: If the BluClik switch is in the wrong position, some functions may still work but some will not work properly.
2) Open the phone’s Bluetooth menu and search for available devices.
3) Select “BluClik” from the list.
4) Once paired with the smartphone, please continue to the control section of the instructions.
Note: When pairing more than one device to the BluClik, turn off the Bluetooth of the first paired device, then flip the
switch on the BluClik to center and repeat steps 1-4. This step can be repeated for a total of three (3) devices.
The BluClik will forget the oldest paired device when a fourth device is added.
Control (after successful pairing)
Increases the phone’s volume
Decreases the phone’s volume
Skips to the next track
Lift to remove
interchangeable
trim rings
Skips to the previous track (supported apps only)
Microphone button
Single press – Play / Pause
Press and hold for 2 seconds will launch
Siri / Android voice control
Sleep Mode
If no buttons are pressed after ten minutes, the BluClik will go into sleep mode to conserve energy and extend the life
of the battery between charges. Once the BluClik is in Sleep Mode, a single press of any button is required to wake up
the BluClik which will then re-connect with your device. After just a few seconds, any button can be pressed to send
the desired command.
Charging
The BluClik has an internal re-chargeable battery that will last up to 60 days on a single charge, however battery life
will vary depending on frequency of usage and other factors. If the BluClik fails to re-connect to a device, it most
likely needs to be charged. Simply remove the BluClik from the holder and plug it into any standard micro USB power
source, such as a car/home charger or computer port, and leave plugged in for approximately one hour.
Once charged, simply press any button to bring it out of sleep mode for use.
A Division of AAMP of America | 13190 56th Court, Clearwater, FL 33760
www.isimplesolutions.com
support@isimplesolutions.com
866-788-4237
Mounting Options
The BluClik has two mounting options. Please choose your preference, then follow the directions for best results.
Steering Wheel Mount (option 1)
1) Determine the best side of the steering wheel for mounting the remote.
2) Place the arm of the mount on the front side of the steering wheel.
3) Thread the Velcro strap around the arm, with the loop positioned on the backside of the steering wheel, and
pull tight and keep tension while attaching.
4) Place the remote in the holder with the + symbol at the top.
velcro strap
mount
arm
loop
Dash Mount (option 2)
1) Determine the best, flat surface, mounting location.
2) Ensure that the surface is free of dirt and oil, clean with a soft cloth and rubbing alcohol if necessary.
3) Peel and stick the dash mount holder in the determined mounting location
4) Place the remote in the holder with the + symbol at the top or toward the front of the vehicle.
Warning:
This equipment may be reset by unintentional electrostatic discharge during operation.
Exposure to direct sunlight or extreme heat may cause damage or malfunction.
peel and stick adhesive backing
for dash mount option
FCC Class B Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installa-tion. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1. Re-orientate or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that of which the receiver is connected.
4. Consult the dealer or an experienced radio / television technical for help.
Notice:
The changes or modifications not expressly approved by the party responsible compliance could void the user authority to operate the equipment.
iPad, iPhone, iPod, and iPod touch are trademarks of Apple Inc., registered in the U.S. and other countries. Lightning is a trademark of Apple Inc.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by AAMP of America™ is under license.
A Division of AAMP of America | 13190 56th Court, Clearwater, FL 33760
www.isimplesolutions.com
support@isimplesolutions.com
866-788-4237
FCC Caution.
§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
* RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device can be used
in portable exposure condition without restriction.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39
Create Date                     : 2014:03:14 16:19:16-04:00
Metadata Date                   : 2014:04:16 01:02:34+08:00
Modify Date                     : 2014:04:16 01:02:34+08:00
Creator Tool                    : Adobe InDesign CS5 (7.0)
Page Image Page Number          : 1, 2
Page Image Format               : JPEG, JPEG
Page Image Width                : 256, 256
Page Image Height               : 256, 256
Page Image                      : (Binary data 11052 bytes, use -b option to extract), (Binary data 10735 bytes, use -b option to extract)
Instance ID                     : uuid:c1dc31f7-9272-467c-8915-e8a03d9aee4a
Document ID                     : xmp.did:0180117407206811871FF7A433403642
Original Document ID            : xmp.did:0180117407206811871FF7A433403642
Rendition Class                 : proof:pdf
History Action                  : created, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved
History Instance ID             : xmp.iid:0180117407206811871FF7A433403642, xmp.iid:0380117407206811871FF7A433403642, xmp.iid:0480117407206811871FF7A433403642, xmp.iid:0680117407206811871FF7A433403642, xmp.iid:0880117407206811871FF7A433403642, xmp.iid:0A80117407206811871FF7A433403642, xmp.iid:FB70428719206811871FF7A433403642, xmp.iid:FD70428719206811871FF7A433403642, xmp.iid:FF70428719206811871FF7A433403642, xmp.iid:0171428719206811871FF7A433403642, xmp.iid:F87F1174072068118C14905B3378FD3B, xmp.iid:FA7F1174072068118C14905B3378FD3B, xmp.iid:FC7F1174072068118C14905B3378FD3B, xmp.iid:02801174072068118C149E30B949656A, xmp.iid:04801174072068118C149E30B949656A, xmp.iid:06801174072068118C149E30B949656A, xmp.iid:08801174072068118C149E30B949656A, xmp.iid:0A801174072068118C149E30B949656A, xmp.iid:BDB5B375072068118C14D59E2B05A9B9, xmp.iid:BEB5B375072068118C14D59E2B05A9B9, xmp.iid:C0B5B375072068118C14D59E2B05A9B9
History When                    : 2014:03:05 13:44:13-05:00, 2014:03:05 14:03:57-05:00, 2014:03:05 14:03:57-05:00, 2014:03:05 14:08:37-05:00, 2014:03:05 15:10:52-05:00, 2014:03:05 15:26:14-05:00, 2014:03:05 15:53:36-05:00, 2014:03:05 17:25:59-05:00, 2014:03:05 17:27:10-05:00, 2014:03:05 17:28:49-05:00, 2014:03:12 16:21:40-04:00, 2014:03:12 16:34:07-04:00, 2014:03:12 16:34:41-04:00, 2014:03:13 10:29:26-04:00, 2014:03:13 10:35:26-04:00, 2014:03:13 10:35:51-04:00, 2014:03:13 10:51:55-04:00, 2014:03:13 11:06:45-04:00, 2014:03:14 16:16:47-04:00, 2014:03:14 16:17:44-04:00, 2014:03:14 16:18:13-04:00
History Software Agent          : Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0
History Changed                 : /;/metadata, /metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata
Doc Change Count                : 931
Format                          : application/pdf
Producer                        : Adobe PDF Library 9.9
Trapped                         : False
Page Count                      : 3
Creator                         : Adobe InDesign CS5 (7.0)

EXIF Metadata provided by EXIF.tools