ACE ELECTRONICS ONA17AA015 CD MINI STEREO SYSTEM User Manual UserMan

ACE INTERNATIONAL ELECTRONICS LTD CD MINI STEREO SYSTEM UserMan

UserMan

PRODUCT GUIDEModel: ONA17AA015CD MINI STEREO SYSTEM
2• Do not ingest the battery, Chemical Burn Hazard• (The remote control supplied with)This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death.• Keep new and used batteries away from children.• If the battery compartment does not close securely, stop using the product and keep it away from children.• If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.WARNING
37. Do not block any ventilation openings. Install in accor-dance with the manufacturer‘s instructions.backDo not expose the apparatus to dripping or splashing. Do not place objects filled with liquids (e.g., vases) on top of the apparatus.• Adapter is used as disconnect device and it should remain readily operable during intended use. In order to disconnect the apparatus from the mains completely, the adapter should be disconnected form the mains socket outlet completely. .(amplifiers that produce heat15. Power Sources - This product should be connected to a power supply only of the type described in these operating instructions, or as marked on the unit. 16. Water and Moisture - This product should be kept away from direct contact with liquids. The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus.17. CAUTION – Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. Batteries (a battery pack or an installed battery) shall not be exposes to excessive heat such as sunshine, fire, etc.19. Do not install this equipment in a confined or "boxed-in" space such as a bookcase or similar unit, and maintain good ventilation conditions. The ventilation should not be impeded by covering the ventilation openings with items such as newspaper, tablecloths, curtains, etc.20. This apparatus is for professional use only.22. WARNING: Please refer to any important information (e.g., electrical, safety, etc.) printed on the exterior bottom enclosure or rear panel before installing or operating the product.21. When moving or not using the appliance, secure the power cord (e.g., wrap it with a cable tie). Be careful not to damage the power cord. Before using it again, make sure the power cord has not been damaged. If the power cord has been damaged at all, bring the unit and cord to a qualified service technician for repair or replacement as specified by the manufacturer.18. Where the mains plug or an appliance c disconnect device, the disconnect device shall remain re operable. NOTICE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference FCC RF Radiation Exposure StatementThis equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body.oupler is used as the adily
4FeaturesIncluded• CD player: CD, CD-R/ RW • Full-range speakers• Preset EQ (4)• Line input• AM/FM stereo radio• Station memory presets/AMS(automatic memory store)• Digital clock• Remote control• Timer• RCA stereo inputs• Vertical loading CD player.• Stereo headphone jack • ONA17AA015• AC adapter• Remote control•Product guide HOME MUSIC SYSTEM WITH CD PLAYERSPECIFICATIONS AC Adapter..............................................................Input ：100-240V～50/60Hzz Output：5V 2.3APower Source（Remote Control）..............DC 3V，CR2025，Lithium BatterySpeaker........................................................................................................4ohm x 2Output Power............................................................................2.5W x 2 10%THDRADIO SECTIONGENERALFrequency Range......................................................................FM：87.5 - 108MHz Specifications are subject to change and improvement without notice. Actual product may vary from the images found in this document.Dimensions.............. Main Unit：6.9in x 3.9in x 9.5in(17.5cm x 9.9cm x 24.2cm)Speaker: 5.1in x 3.9in x 9.5inx2(13cm x 9.9 cm x 24.2 cm x 2)
5INTRODUCTION 6891011SETUPCD , BLUETOOTH CLOCK AND ALARMRADIO, AUXILIARY INPUT, AND LINE INPUT
INTRODUCTION61 . CD DOOR2. POWER 3. FUNCTION 4. OPEN 5. LCD DISPLAY 6. STOP7. PLAY/PAUSE/PAIRING8. 10 11 12 13 14 15 16. 10 . DC IN11 . HEADPHONE12 . SPEAKER OUT -R13 . SPEAKER OUT -L14 . AUX IN-R15 . AUX IN-L16 . LINE INTUNINGVOLUME9 123456987
STANDBYPAIRINGFUNCTIONCLK PROG7DISPLAYPress to view theclock on the LCDdisplay.STANDBYPress the STANDBY the unit. Press it to turn has sounded.TUNE/SKIP/SEARCHIn radio mode, press the TUNE/SKIP/SEARCH button to tune the AM or FM radio frequency.In CD mode, press it to select the tracks. Long press to search the track with a high speed.MODE/CLK PROGpress the MODE/When playing a CD,CLK PROG button once to repeat a single song and twice to repeat an entire album.When CD is stopped,When the unit is OFF, Press it to programa CD.press to set the clock.In Radio mode,press it to save an AMor FM radio station.FUNCTIONPress the FUNCTIONbutton to switchCD, Radio,and AUX mode,and Bluetooth.STOPIn CD mode, press the STOP button to stopa CD during play.In radio mode, press it to switch FM radio mode.PLAY/PAUSE/PAIRING/M+In CD mode, press the PLAY/PAUSE/PAIRING/M+ buttonto play or pause a loaded CD. to recall the saved AM or FMIn radio mode, press the buttonradio station.In bluetooth mode, long press to disconnect. EQPress the EQ button to switch between Rock,Pop,Jazz,or Classic EQ settings.MUTEPress the MUTE buttonto decrease thevolume entirely.VOLUMEPress the VOLUMEbuttons to increaseor decrease the volumelevel.SLEEP/ALARM SETPress the SLEEP/ALARM SET button to set the when the unit is turned OFF. press button to chose FM mono or ST.sleep timer.Press it to set the alarmSNOOZE press the SNOOZE sounds, button to delay thealarm for an additional9 minutes.In radio mode,
8PowerSpeakersSETUPPlug the attached 5V/2.3A adapter into a standard AC power outlet to power the home theater system.Plug the speaker cables into the corresponding colored speaker outputs. RemoteRequires 1 CR2025 battery (pre-installed)LITHIUM BATTERYCR 20253VCR2025PUSHOPENLITHIUM BATTERYCR 20253VCR2025PUSHOPEN
CDPlaying a CD Programming a CDon this uniIf this is your first time playing a CDt, remove the cardboard disc from behind the CD DOOR before attempting to play an actual CD.1 Press the OPEN button to open the CD DOOR.2 Insert a CD into the unit P4Press the MODE/CLK/PROG buttonto select the play mode as followingsequence:Normal Repeat 1 Repeat all Random Normal. ress the 3 Press the POWER buttonto turn on the unit.FUNCTION button until the unit is in CD mode.The loaded CD will play automatically.1 Follow the steps for “Playing a CD”, then press the STOP/BAND button.2 Press the MODE/CLK/PROG button.“PROGRAM”and“ P-01” will appear on the LCD display, indicating that the unit is in program mode, and it is ready for the first track to be selected. 3 Press the SKIP/TUNE buttons to select the track as your desire.4 Press the MODE/CLK/PROG buttonto select a track.“P-01” will change to“P-02”.55 Repeat steps 3, 4, and 5 until the desired CD tracks are programmed.6 Press the PLAY/PAUSE/M+ button to play the programmed tracks.7 tracks,press the MODE/CLK/PROG button repeatedly in stop mode. If you went to review the programmed9streaming music and audio with Bluetooth wireless Turn on the unit by pressing the STANDBY Button. disconnect the current paired Bluetooth audio device or make sure the current device has been moved out of range. Please the MODE button to set the unit to “ BT” mode. Next, press the PAIRING button on the top of the unit. “ONA17AA015”will appearONA17AA015 on your Bluetooth. enabled device Select your Bluetooth audio device to connect to the ONA17AA015.If you wish to pair the“ONA17AA015” from the available list and During playback, press the PLAY / PAUSEbutton to pause playback and again to resume playback While in STOP mode, you can press SKIP UP + or SKIP DOWN button to select a aspecific track for playback. –To skip forward or backward on the disc, press the SKIP UP + or SKIP DOWN – button to skip to the beginning of the next track or the beginning of the previous track
CLOCK AND ALARMSetting the ClockSetting the Sleep TimerSetting the AlarmCancelling the Alarm1 Press the STANDBY button to turn2 Press the MODE/CLK/PROG button, the display will flash the time. button the display will flash the time.3 Press the SKIP/TUNE SKIP/TUNE buttons to adjust the hour and minute. 3 Press the buttons to adjust the hour and minute. A PM INDICATOR will appear on the display when the time is set in the PM. Make sure to set the correct AM/PM as desired.4 Press the MODE/CLK/PROG button to confirm the adjusted time.1 Press the STANDBY button until the unit is turned on.When the unit is on, the POWER button will not be illuminated red.2 Press the SLEEP/ALARM SET buton until “SLEEP” appears on the LCD.3 Press the SLEEP/ALARM SET button consecutively to adjust the sleep timer between 0 and 90 minutes.4 After the allotted time has expired, 1 Press the SLEEP/ALARM SET button twice to cancel the alaNote:Note:When the sleep time is 00,It’s meaning“sleep”icon will disappear.Note:rm.The ALARM icon on the display will disappear.2 simply press the SLEEP/ALARM SET button again.The ALARM icon will appear on the display.1 Press the STANDBY button to turn5 Press the FUNCTION button to select CD, RADIO, or BUZZER. For BUZZER mode, the display will not show any indication.2 Press and old SLEEP/ALARM SET A PM INDICATOR will appear on thedisplay when the time is set in the PM.Make sure to set the correct AM/PM as desired.4 Press the SLEEP/ALARM SET button to confirm the adjusted alarm time. An alarm clock icon will appear on the LCD Display when the alarm is set. sounded, press the STANDBY button.10 To search forward or backward on the disc, press and hold the SKIP UP + or SKIP –DOWN button to search within the track currently playing.note: If the last paired Bluetooth audio device is powered on and within range with Bluetooth enabled, the device will automatically reconnect to the ONA17AA015.
11RADIO, AUXILIARY INPUT, AND LINE INPUTUsing the Line Input1 Tune the radio to the station you want to save.2 Press the MODE/CLK/PROG button to enter the program mode,then to select a preset number. press the PLAY/PAUSE/M+ button3 Press the MODE/CLK/PROG button again to save the current station. Repeat steps 1/2/3 to program morestations. You can program up to 20 FM presets and 10 AM presets. Requires a RCA Cable (not included)1 Connect an audio device to the AUXILIARY INPUT.2 Press the FUNCTION button to set the unit to AUX mode as indicate on the LCD Display.The AUXILIARY INPUT will not work when a device is connected to the LINE INPUT.3 The audio device will play throughthe speakers.play throughthe speakers. The audio device will Requires a Line Input Cable (not included)2 Press the FUNCTION button to set the unit to AUX mode as indicated on the LCD Display. When the LINE INPUT is connected, the AUXILIARY INPUT will not work.3 1 Press the STANDBY button until the unit is turned on.2 Press the FUNCTION button to set the unit to Radio mode as indicateon the LCD Display.3 Press the STOP button to selectFM radio bands.adjust the radio frequency.Using the Auxiliary Input Using the Radio44 P5 Press and hold “play/pause/M+”toenter into searching station automatically. ress the SKIP/TUNE buttons to Saving with Program1 Connect audio devices including phones, tablets and mp3 players to theNote: Note: LINE INPUT.

Navigation menu