ADC Telecommunications FWM1901A FlexWave™ microBTS User Manual Manual Addendum

ADC Telecommunications Inc FlexWave™ microBTS Manual Addendum

User manual 02

Download: ADC Telecommunications FWM1901A FlexWave™ microBTS User Manual Manual Addendum
Mirror Download [FCC.gov]ADC Telecommunications FWM1901A FlexWave™ microBTS User Manual Manual Addendum
Document ID801790
Application IDw3/OVD0rD36Z0JjUmdmhIQ==
Document DescriptionUser manual 02
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize2.09kB (26081 bits)
Date Submitted2007-06-10 00:00:00
Date Available2007-06-10 00:00:00
Creation Date2007-05-17 09:14:47
Producing SoftwareAcrobat Distiller 7.0.5 (Windows)
Document Lastmod2007-05-17 09:14:47
Document TitleMicrosoft Word - Manual Addendum.doc
Document CreatorPScript5.dll Version 5.2.2
Document Author: miskam

Addendum CENG0210_XB Hardware Installation – nanoBTS
FlexWave™ microBTS
Operation and Maintenance Manual Addendum
PRODUCT DESCRIPTION
This publication provides basic information about the FlexWave™ microBTS. Place
this addendum with CENG0210_XB Hardware Installation manual for the nanoBTS.
The FlexWave microBTS provides the same functionality as the nanoBTS. However,
the microBTS utilizes an additional Linear Power Amplifier, and combines four nanoBTS units
into one single chassis. This chassis is functional for indoor and outdoor installation. The
chassis provides the degree of protection specified by NEMA 6 and IP67 as defined by IEC
Publication 60529.
INSTALLATION OVERVIEW
Mounting
The microBTS may be mounted on a flat vertical surface (such as the side of a
building) or on a utility pole. A combination wall/pole mounting bracket is provided with
each unit. A separate stand mount kit (accessory item) is available if it is necessary to
mount the microBTS from a cable. A grounding lug is provided on the bottom of the
microBTS enclosure for connecting a grounding wire.
Mailing Address: P.O. Box 1101, Minneapolis, Minnesota 55440-1101
World Headquarters: Minneapolis, Minnesota USA +1.952.938.8080 www.adc.com
FlexWave™ microBTS Nominal Specifications:
PARAMETER
SPECIFICATION
System bandwidth
60 MHz
Frequency range
1930 – 1990 MHz
Out-of-band emissions
-13 dBm per 1 MHz bandwidth
from 30 MHz to 20 GHz
Passband Gain
18.5 dB
Composite RF Output power
(see Note 1 at end of table)
41.5 dBm (14.13 Watts) at
antenna port
Gain variation
± 3 dB over temp and unit-tounit
Gain flatness
Band flatness
Channel flatness
Mounting
Operating Temperature
Antenna Connector
Voltage Input
± 1.5 dB across freq. range
± 1.0 dB across any 1.25 MHz
channel
Pole, wall, or strand mounted
-5° C to +45° C
50 ohm N-Type (Female)
100-250 VAC, 47-63 Hz
REMARKS
Addition to +23 dBm gain
setting on each nanoBTS
40.5 dBm (11.22 Watts)
for Industry Canada using
two tone method
50 ohm output impedance
Note 1: Per Industry Canada Section 5.3 - The Manufacturer's rated output power of this equipment is for single
carrier operation. For situations when multiple carrier signals are present, the rating would have to be reduced by
3.5 dB, especially where the output signal is re-radiated and can cause interference to adjacent band users. This
power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the
device."
STANDARDS CERTIFICATION
FCC: This equipment complies with the applicable sections of Title 47 CFR Part 24 (1900
MHz)
IC: This equipment complies with the applicable sections of RSS-131. The term “IC:” before
the radio certification number only signifies that Industry Canada Technical Specifications
were met.
Caution: Modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note: To comply with Maximum Permissible Exposure (MPE) requirements, the maximum
composite output form the antenna cannot exceed 1000 Watts EIRP and the antenna must
be permanently installed in a fixed location that provides at least 6 meters (20 feet) of
separation from all persons.
Mailing Address: P.O. Box 1101, Minneapolis, Minnesota 55440-1101
World Headquarters: Minneapolis, Minnesota USA +1.952.938.8080 www.adc.com

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
XMP Toolkit                     : 3.1-701
Producer                        : Acrobat Distiller 7.0.5 (Windows)
Creator Tool                    : PScript5.dll Version 5.2.2
Modify Date                     : 2007:05:17 09:14:47-05:00
Create Date                     : 2007:05:17 09:14:47-05:00
Format                          : application/pdf
Title                           : Microsoft Word - Manual Addendum.doc
Creator                         : miskam
Document ID                     : uuid:c0425d36-3a80-4a5a-8459-dae79bd2945f
Instance ID                     : uuid:b15c49de-4bb7-4495-800d-a2712b5edd2b
Page Count                      : 2
Author                          : miskam
EXIF Metadata provided by EXIF.tools
FCC ID Filing: F8I-FWM1901A

Navigation menu