ALPS ALPINE WK1A002 Immobilizer Antenna User Manual user manual
Alps Electric Co., Ltd. Immobilizer Antenna user manual
User Manual
The connector is arran
g
ed as shown in the fi
g
ure below.
Terminal No. I/O
1-
2I
3 I/O
4-
■CAUTION■
Operating temperature
range
-40~＋85 degree C
MAX 0.5mA(@12.5V 25℃) at standby
Weight
Please DO NOT the following. Engine is not started by failure of
electronic parts. (Product can not receive the signal correctly)
Pay attention to the following.
(The operation range might be changed by the environment. )
・Do not contact and bring metals close to the engine SW and the
key.
・It may not be operated when using the equipment of the same
frequency band in the vicinity.
0.03kg
Consumption current
s
p
ec
MAX 100mA(@12.5V 25℃) at operation
User's Manual
+B
CLOCK
DAT
A
It communicates with IC used both as Transponder and Passive RKE
through LF ANT(Z axis) of I-key H/U, and operates as ANT to exchange
communication data depending on community signal with BCM.
The immobilizer antenna communicates with the transponder in the
hand unit when the hand unit is brought close, and receives the code of
the key. The immobilizer is used by bringing the hand unit close as
shown in figure.
Product name : IMMOBILIZER ANT
Type : TWK1A002
Terminal Name
FCC WARNING
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Size
・Give a shock.
・Get it wet. If it got wet, wipe and dry up.
・Disassembly and modification.
This device complies with Part 15 of FCC Rules and RSS-Gen of IC
Rules. Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation
of this device.
Operation of frequency 125kH
z
DC8～16
V
GND
A
C/DC Suppl
y
Operating voltage DC8～16V(Inner:DC 5V)
DC12
V
Range of voltage
Consumption current Under 0.5m
A
（Standby current）
W40xL62xH49（mm）
HUND UNIT IMMOBILIZER