ALPS ALPINE WK1A0028 Immobilizer base station User Manual 05

Alps Electric Co., Ltd. Immobilizer base station 05

(Short-Term Confidential) User Manual

　The connector is arranged as shown in the figure below■CAUTION■Operating temperaturerange -40~＋85　degree CMAX 1.0mA(@12.5V 25℃) at standbyWeight Please DO NOT the following. Engine is not started by failure ofelectronic parts. (Product can not receive the signal correctly) Pay attention to the following.(The operation range might be changed by the environment. )・Do not contact and bring metals close to the engine SW and thekey.・It may not be operated when using the equipment of the samefrequency band in the vicinity.0.054kgConsumption currentspec MAX 200mA(@12.5V 25℃) at operationUser's Manual　It communicates with IC used both as Transponder and Passive RKEthrough LF ANT(Z axis) of I-key H/U, and operates as ANT to exchangecommunication data depending on community signal with BCM.　The immobilizer antenna communicates with the transponder in the handunit when the hand unit is brought close, and receives the code of the key.The immobilizer is used by bringing the hand unit close as shown inProduct name : Immobilizer base stationType : TWK1A0028FCC WARNINGChanges or modifications not expressly approved by the party responsiblefor compliance could void the user’s authority to operate the equipmentSize・Give a shock.・Get it wet. If it got wet, wipe and dry up.・Disassembly and modification. This device complies with Part 15 of FCC Rules and RSS-Gen of ICRules. Operation is subject to the following two conditions: (1) this devicemay not cause interference, and (2) this device must accept anyinterference, including interference that may cause undesired operation ofOperation of frequency 125kHzDC6V～16VAC/DC SupplyOperating voltage DC6～16V(Inner:DC 5V)DC12VRange of voltageConsumption current Under 1.0mA（Standby current）W40.2xL70xH40.2（mm）HUND UNIT Immobilizer base stationCONNECTORPINLAYOUT

Navigation menu