Abocom Systems AOP7120 AOP7120 Super WiFi CPE/AP User Manual
Abocom Systems Inc AOP7120 Super WiFi CPE/AP Users Manual
Users Manual
LAN Use standard LAN cables (RJ45
connectors) to connect your PCs to
this port. If required, any port can
be connected to other hub. Any
LAN port will automatically function
as an “Uplink” port when necessary.
WAN 1. Connect a 24V PoE switch to
get power with RJ45 cable.
2. Connect the ADSL or Cable
Modem to a PoE switch to get
Internet connection. If your
modem came with a cable, use
the supplied cabled, otherwise,
use a standard LAN cable.
Quick Install Guide
AOP7120 Super WiFi CPE/AP
1
Hardware Overview
Hardware Connection
2
Step1. Connect to your local area network:
connect the Ethernet cable to LAN
port of the device, and the other end
to a PC, hub, switch, router or other
Wireless Access Point.
Step2. Power on the device: power on the
device by PoE switch via WAN port.
Step3. Check the LEDs: the power LED
should be always on when system is
ready.
Login
Software Configuration
3
Wireless_2.4G
DefaultSSID: OpenWRT2G
Security: none
1. Start your computer and make sure the
connection by an Ethernet cable between
your computer and the Wireless Router.
2. Start your WEB Browser.
3. In the Address box, enter the IP address:
192.168.1.1
4. Login User Name “admin” and Password
“password”
FCC Statement:
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
● Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Wireless_5G
DefaultSSID: OpenWRT5G
Security: none
For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other
channels is not possible.
This device and it's antennas(s) must not be co-located or operating in conjunction with any other antenna
or transmitter except in accordance with FCC multi-transmitter product procedures.
This device is restricted for indoor use.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20 cm
between the radiator & your body.
Operating temperature : -20OC ~ 60OC.
Rating: 24V—1.04A Max