Aclara Technologies 2015002 LLB2015002 User Manual LLB2015002 Users Manual

Aclara Technologies LLC LLB2015002 LLB2015002 Users Manual

Contents

User Manual

ACLARA Technologies LLC 30400 Solon Road. Solon, OH 44139 440-528-7200 May 8th 2015 Users Manual FCC ID: LLB2015002 The LLB2015002 has no user adjustment or controls and are installed by factories trained personnel at the manufacturing facility .Aclara Technologies LLC. LLB2015002 devices are shipped to the customer in the sealed LLB2015002 enclosures. Thus, NO operational access can be made in the field, without breaking the factory sealed enclosure. The FCC wants you to know….. This equipment has been tested and complies with Part 15 and Part 90 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, try to correct the interference by one or more of the following measures: • Reorient or relocate the equipment. • Increase the separation distance between the affected equipment and receiver. • Consult Hexagram, Inc. for help. Any changes or modifications to this equipment not expressly approved by the Hexagram, Inc. could void the authorization to operate the equipment. FCC RF Exposure Guidelines Aclara’s low power RF devices and their antennas must be fixed-mounted on indoor or outdoor permanent structure(s) providing a separation distance of at least 20 cm from all persons during normal operation. This device is not designed (and it has no external connection) to operate in conjunction with any other antennas or transmitters. No other operating instructions for satisfying RF exposure compliance are needed. This unit has no user or installer serviceable parts, and requires no field adjustment or calibration. Units are sealed at the factory, and disruption of this seal could void the authorization to operate the equipment. Sincerely, Siva Jambulingam Principal RF Engineer

Navigation menu