Aclara Technologies 2015002 LLB2015002 User Manual LLB2015002 Users Manual

User Manual

ACLARA Technologies LLC

30400 Solon Road.

Solon, OH 44139

440-528-7200

May 8

2015

Users Manual

FCC ID: LLB2015002

The LLB2015002 has no user adjustment or controls and are installed by factories trained personnel at

the manufacturing facility .Aclara Technologies LLC. LLB2015002 devices are shipped to the customer

in the sealed LLB2015002 enclosures. Thus, NO operational access can be made in the field, without

breaking the factory sealed enclosure.

The FCC wants you to know….. This equipment has been tested and complies with Part 15 and Part 90

of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference. This equipment generates, uses and can radiate radio frequency energy, and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, try to correct the interference by one or

more of the following measures: • Reorient or relocate the equipment. • Increase the separation distance

between the affected equipment and receiver. • Consult Hexagram, Inc. for help. Any changes or

modifications to this equipment not expressly approved by the Hexagram, Inc. could void the

authorization to operate the equipment.

FCC RF Exposure Guidelines Aclara’s low power RF devices and their antennas must be fixed-mounted

on indoor or outdoor permanent structure(s) providing a separation distance of at least 20 cm from all

persons during normal operation. This device is not designed (and it has no external connection) to

operate in conjunction with any other antennas or transmitters. No other operating instructions for

satisfying RF exposure compliance are needed. This unit has no user or installer serviceable parts, and

requires no field adjustment or calibration. Units are sealed at the factory, and disruption of this seal could

void the authorization to operate the equipment.

Sincerely,

Siva Jambulingam

Principal RF Engineer