Acrox Technologies OPWIRWMU01 Wireless Mouse User Manual G1P MRW Users Guide 2009

Acrox Technologies Co., Ltd. Wireless Mouse G1P MRW Users Guide 2009

Manual

2.4GHz Wireless Optical Mouse USER'S GUIDE Ver.:1.00 CAUTION: To use this product properly, please read the user's guide before installation
1 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
2 Functional Introduction Battery and Power Management: Step 1: Pull the battery cover backward. Step 2: Insert the batteries as shown inside the battery compartment. Step 3: Replace the cover. For Extra usage hours, use two AA batteries instead of two AAA Batteries. **Warning: *Please insert the battery with the correct position according to the instruction labeled on the mouse. Left button Right button Battery Cover LED Indicator RF Receiver Connect Button ON/OFF Switch Scrolling Wheel & LED Indicator Pull out Insert
3 Setup the Connection between the Receiver and the Mouse 1. Plug the RF receiver into the USB port of your computer. 2. Insert the batteries into the mouse, then follow the steps below. 3. If the mouse is not working, please put it into pair mode. 4. Pairing: Re-plug the receiver into the USB port of your computer, then press the connect buttons on the mouse. If the mouse does not work after 10 seconds, pair them again. (The receiver has auto pairing function). 5.The LED indicators on the receiver flashes when the mouse is moving. 6. When the battery of the mouse is low, the Low Power indicator would blink. LED Indicator *Mouse Indicator Red LED Blinking 10 sec. Low Battery Warning Red LED ON 10 sec. Power ON Green LED Blinking Pairing (LED OFF when paired or failed after 10 sec.)
4 LED Indicator Power ON *Receiver Indicator Green LED ON 3 sec. Green LED Blinking (If any action)

Navigation menu