Acrox Technologies OPWIRWMU03 Wireless Mouse User Manual

Acrox Technologies Co., Ltd. Wireless Mouse

user manual

Wireless Mouse / MDG USER'S GUIDE Ver.:1.00 CAUTION: To use this product properly, please read the user's guide before installation
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation
ON/OFF Switch Functional Introduction Forward Press this button to view the next page of the Internet browser. Backward Press this button to view the pervious page of the Internet browser. DPI Switch The brightness of LED indicator on the DPI switch indicates the DPI setting in use. There are three different settings: z Bright: 1600 DPI z Dim: 1200 DPI z No light: 800 DPI The default setting is 1600 DPI. You can easily switch between DPI settings. In order to save power, the LED display will only last for 10 Right button Left button Backward Forward LED Indicator RF Receiver Connect Button DPI switch / LED Indicator Tilt Wheel
seconds. Installing the batteries Step 1: Take the battery cover off. Step 2: Insert the batteries as shown inside the battery compartment. Step 3: Replace the cover. Setup the Connection between the Receiver and the Mouse 1. Plug the RF receiver into the USB port of your computer. 2. Insert the batteries into the mouse, then follow the steps below. 3. If the mouse is not working, please put it into pairing mode. AA Battery
4. Pairing: Re-plug the receiver into the USB port of your computer, then press the connect button on the mouse. If the mouse does not work after 10 seconds, pair them again. (The receiver has auto pairing function). 5.The LED indicator on the receiver flashes when the mouse is moving. 6. When the batteries of the mouse is low, the Low Power indicator will start to blink. 7. Please see the readme for details. LED indicator LED Indicator *Mouse IndicatorRed LED Blinks for 10 sec. Low Battery Warning Red LED is on for 10 sec. Power ON Green LED Blinking Pairing (LED OFF when paired or failed after 10 sec.) Power ON *Receiver IndicatorGreen LED is on for 3 sec. Green LED Blinking (If any action)

Navigation menu