Acrox Technologies OPWISMMU01 2.4GHz Optical Mouse User Manual 410 1098 006B AMW25AP 07Aug31 full
Acrox Technologies Co., Ltd. 2.4GHz Optical Mouse 410 1098 006B AMW25AP 07Aug31 full
Manual
2.4GHz Optical Mouse Model Name MA5 USER GUIDE Features and specifications are subject to change without notice. All trademarks are the property of their respective owners © 2007, Targus Group International, Inc. and Targus, Inc. Manufacturer / Importer: Unit 1202-07, 12/F, Tower 2, Metroplaza, No. 223 Hing Fong Road, Kwai Fong, N.T. Hong Kong AMW25AP / 410-1098-006B 30 2.4GHz OPTICAL MOUSE Introduction Congratulations on your purchase of the 2.4GHz Optical Mouse Notebook Mouse. This mouse features a tracking resolution switch users who require more precision or speed with various application The Stow-N-Go receiver clips onto the mouse for ease of use which traveling or on the go. This mouse also features a 4-way scrolling wheel which allows for both vertical and horizontal navigation. System Requirements • • • • Hardware - USB port Windows® 2000/XP Windows Vista™ Mac OS X 10.2.8 (or greater) Installing the Batteries 1. Remove the battery cover from the back of the mouse by sliding off the cover of the mouse. Hold the mouse in your hands and with the back of the mouse away from you. Press down on the corners of the battery cover and slide towards the back of the mouse. Lift the cover off from the back of the mouse. 2. Insert two AA-size batteries, making sure that the positive (+) and negative (-) ends of each battery match the polarity indicators inside the battery compartment. To replace the battery cover, place the cover on top of the mouse and slide forward until it clicks into place. NOTE: WHEN THE BATTERY IS LOW, THE LOW POWER INDICATOR LIGHT LOCATED IN THE DPI SWITCHING BUTTON WILL FLASH RED. PLEASE REPLACE WITH TWO NEW AA-SIZE BATTERIES. DPI switching button When power is on, the mouse goes into "sleep mode" after 8 minutes of inactivity. To activate the mouse, press any mouse key. Establishing the Connection (A) Remove the USB receiver from the bottom of the mouse. This will activate the on/off switch. NOTE: TO TURN THE MOUSE OFF, SIMPLY PLACE THE USB RECEIVER BACK INTO THE STORAGE SLOT. THIS WILL MAXIMIZE BATTERY LIFE WHEN NOT IN USE. (A) (B) Plug the USB receiver into an available USB port on your computer. (C) Press and release the setup key on the receiver. (C) (B) (D) Press the setup key on the bottom of the mouse. (D) This device has 256 identification codes that allow the mouse and its receiver to operate without interference from other radio frequency devices. If you experience interference during use, repeat steps C and D to change the connection channel. Installing the tilt-wheel software driver This mouse is equipped with a 4-way scrolling function. To enable the tilt-wheel function, the software driver must be installed. NOTE: THE TILT-WHEEL FEATURE IS SUPPORTED BY THE MAC OPERATING SYSTEM. NO DRIVER INSTALLATION IS NECESSARY. THE FOLLOWING STEPS ARE FOR WINDOWS OPERATING SYSTEMS ONLY. 1. Please download the software driver (Model # AMW25) from the official Targus web site: http://www.targus.com Save the setup.exe file to your computer and double click on the icon to launch the installation process. 2. The Installation Wizard window will prompt. Follow the on-screen instructions to complete the installation. NOTE: PLEASE SELECT THE "3 BUTTON MOUSE" OPTION WHEN PROMPTED TO DO SO. After the software driver is successfully installed, there will be a “Tilt Mouse” icon located in the task bar. Using the 4-way scrolling tilt-wheel Pressing the scroll-wheel left or right, enables the horizontal scrolling feature. NOTE: DOUBLE CLICK ON THE “TILT MOUSE” ICON IN THE TASK BAR WILL LAUNCH THE MOUSE SETTINGS SCREEN. YOU CAN EDIT THE SETTINGS AND PREFERENCES IN THIS WINDOW. Activating the Universal Zoom function The Universal Zoom function can be enabled in the Mouse Setting screen. In the Mouse Setting screen, under the Button tab, scroll down the function list and select the Universal Zoom function then click Apply. Press on the scroll wheel to activate the zoom function. Adjusting the DPI Setting This mouse features 3 selectable resolution settings (1600 / 1200 / 800 DPI). By pressing the resolution switch, you can instantly adjust the tracking speed of the mouse. When the DPI is set at 1600, the indicator light will glow brightest and when it is set at 1200, the light will become dimmer. The indicator will be off when the DPI is set at 800 DPI. The setting will be saved when the mouse is turned off. The indicator light will shut off in 10 seconds after selecting the desired resolution. 1600 DPI 1200 DPI 800 DPI Windows XP: After selecting the desired resolution, you can also fine tune the sensitivity. This can be adjusted in the “control panel” of the Windows operating system. Click on Start --> Setting --> Control Panel --> Mouse In the “mouse properties” window, locate the “pointer options” tab. Under “motion”, use the slider to change the speed of the mouse. Click apply to confirm the changes. Windows XP Mac OS: After selecting the desired resolution, you can also fine tune the sensitivity. This can be adjusted in the “System Preference” of the Mac operating system. Click on the Apple logo --> System Preference --> Keyboard & Mouse In the “Keyboard & Mouse” window, locate the “Trackpad” tab. Under “tracking speed”, use the slider to change the speed of the mouse. Mac OS Product Specification Transmitter RF Battery Type Effective RF Communication Range RF output Power Power Consumption • 2.4GHz • Alkaline battery AA • 1.2 meters max • 1mW max • 15mA max Receiver RF Interface Power • 2.4GHz • USB 1.1 • USB Bus Powered 5V DC This mouse is equipped with the latest sensor technology that conserves power and provides up to six months of battery life. Battery life is determined using one hour of continuous use, five days per week. Regulatory Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Statement Tested to Comply This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna; • Increase the separation between the equipment and receiver; • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected; • Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not authorized by the party responsible for compliance could void the user’s authority to operate this product. Declaration of Conformity Hereby, Targus Group International, declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. Microsoft, Windows, and Windows Vista are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries. All trademarks and registered trademarks are the properties of their respective owners. All rights reserved.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : No Encryption : Standard V2.3 (128-bit) User Access : Print XMP Toolkit : 3.1-701 About : uuid:09c9963e-adfa-4ff2-a13c-218ed5de7df8 Producer : Acrobat Distiller 7.0 (Windows) Create Date : 2007:08:31 11:59:29+08:00 Modify Date : 2008:01:03 13:49:26+08:00 Metadata Date : 2008:01:03 13:49:26+08:00 Creator Tool : Adobe Acrobat 7.0 Document ID : uuid:206C4C897657DC11A826FD38FD482489 Instance ID : uuid:3212d99c-32f1-4854-96eb-cf6920673ec3 Derived From Instance ID : uuid:82292150-96b7-4dd5-a027-506c71206208 Derived From Document ID : uuid:583f7404-9f92-4ceb-82e4-3abd974937db Format : application/pdf Title : 410-1098-006B (AMW25AP_07Aug31)full.pdf Has XFA : No Page Count : 9 Creator : Adobe Acrobat 7.0EXIF Metadata provided by EXIF.tools