Admiral Craft Idw 940 Infrared Display Warmer Owner S Manual

: Admiral-Craft Admiral-Craft-Idw-940-Infrared-Display-Warmer-Owner-S-Manual admiral-craft-idw-940-infrared-display-warmer-owner-s-manual admiral-craft pdf

Open the PDF directly: View PDF .
Page Count: 6

Download
Open PDF In Browser	View PDF

IDW-940W
Infrared Display Warmer

This manual contains important information regarding
your Adcraft unit. Please read the manual thoroughly
prior to equipment set-up, operation and maintenance.
Failure to comply with regular maintenance guidelines
outlined in this manual may void the warranty.
PLEASE READ!!!

WARNINGS
• Do not touch any hot surfaces
• Plug only into a 3-hole grounded electrical outlet
• Do not immerse unit, cord or plug in liquid at any time
• Unplug cord from outlet when not in use and before cleaning
• Do not operate unattended
• Do not use this unit for anything other than intended use
• Do not use outdoors
• Always use on a firm, dry and level surface
• Do not use if unit has a damaged cord or plug, in the event the appliance malfunctions, or has been damaged in any manner
• Keep children and animals away from unit
• Any incorrect installation, alterations, adjustments and/or improper maintenance can lead to property loss and injury. All
repairs should be done by authorized professionals only
• Ensure that the designated power supply is adequate for continual usage and the voltage is correct
TO USE
1. Place unit on a firm and level surface.
2. Plug the unit into a grounded 3-prong 120V outlet.
3. Place food into the food pan located in the base of the unit. A perforated liner is included to allow for proper drainage of
oil from food.
4. Set “HEATING” switch to on position. This will turn the heating elements on and start to warm up the food in the food
pan located in the base of the unit. Please note the maximum temperature that the hot zone area should reach is 122°F
(50°C).
5. Set “LIGHT” switch to on position to turn on display lamp.

CLEANING – NOTE: To maintain cleanliness and increase service life, the oven should be cleaned daily. Do not immerse the unit
in water or any other liquid. If liquid enters the electrical compartment it may cause a short circuit or electrical shock
• Disconnect the power cord from the electrical outlet
• Allow unit to cool down
• Remove food pan daily to clean. Separate perforated liner and food pan for best results
• Clean unit with a damp cloth using a mild detergent
• Do not clean with a water jet stream
• To avoid damage, do not use abrasive cleaners or scouring pads
• If soap or chemical cleaners are used, be sure they are completely rinsed away with clear water immediately after cleaning.
Chemical residue could damage or corrode the surfaces of the unit.
SPECIFICATIONS
Item Number
IDW-940W

Description
Infrared Display
Warmer

Voltage

Wattage

Amps

Net Weight

Dimensions

120V

940W

7.8

15.5 lbs

13”x22.25”x19.75”

Thank you for your purchase
Admiral Craft Equipment Corp.
940 South Oyster Bay Rd.
Hicksville, NY 11801
P: 1-800-223-7750
F: 1-800-447-7751
www.admiralcraft.com

I
DW940W

Ci
r
cui
tDi
agr
am

VER0413

I
DW940W

VER0413

IDW-940W - Infrared Display Warmer
No.
Description
1
Rubber Foot
2
Screw for Foot
3
Base body assembly
4
Switch
5
Faceplate
6
Lamp base
7
Screw for Lamp
8
Lamp
9
Plate to fix heating element
10
Heating element
11
Screw
12
Heat insulation in top box
13
Power cord shealth
14
Power cord with plug
15
Hexagon nut
16
Nut
17
Flat washer
18
Porcelain terminal
19
Plate to isolate the electric parts
20
Preforated Pan Liner

QTY
4
4
1
2
1
1
2
1
1
2
1
4
1
1
1
3
2
1
1
1

1/1

ACE Equipment One Year Limited Warranty
Admiral Craft Equipment Corp. (ACE) warrants its equipment against defects in materials and workmanship, subject
to the following conditions:
ACE Equipment is warranted for one year, effective from the date of purchase by the original owner. A copy of the
original receipt or other proof of purchase is required to obtain warranty coverage. This warranty applies to the original
owner only, and is not assignable.
Should any product fail to function in its intended manner under normal use within the limits defined in this
warranty, at ACE’s discretion, such product will be repaired, replaced with a refurbished unit, or replaced with a new
unit by ACE, after defective unit has been inspected and defect has been confirmed. ACE does not assume any liability
for extended delays in replacing any item beyond its control. This warranty does not apply to rubber and non-metallic
synthetic parts that may need to be replaced due to normal usage, wear or lack of preventative maintenance.
This warranty covers products shipped into the 48 contiguous United States, Hawaii, and metropolitan areas of Alaska
and Canada. Warranty coverage on products used outside the 48 contiguous United States, Hawaii and metropolitan
areas of Alaska and Canada may vary. Contact ACE for details at 1-800-223-7750
The following conditions are not covered by warranty:
•

•
•
•
•

Equipment failure relating to improper installation, improper utility connection or supply and problems due to
improper ventilation.
Equipment that has not properly been maintained, damage from improper cleaning, and water damage
to controls.
Equipment that has not been used in an appropriate manner, or has been subject to misuse, neglect, abuse,
accident, alteration, negligence, damage during transit, delivery or installation, fire, flood, riot, or act of God.
Equipment that has the model number or serial number removed or altered.
Equipment on which the security seal has been broken.

If the equipment has been changed, altered, modified, or repaired without express written permission from ACE, then the
manufacturer shall not be liable for any damages to any person or to any property, which may result from the use of this
equipment thereafter.
This equipment is intended for commercial use only and this warranty is void if equipment is used in other than a
commercial application.
For warranty and non-warranty related issues, technical support, purchase replacement parts and warranty registration
visit www.admiralcraft.com. Please have your model number, serial number and proof of purchase ready. It is not
necessary to contact the place where you originally purchased your product from.
“THE FOREGOING WARRANTY IS IN LIEU OF ANY AND ALL WARRANTIES EXPRESSED OR IMPLIED
INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILTY OR FITNESS FOR PARTICULAR
PURPOSES AND CONSTITUES THE ENTIRE LIABILITY OF ACE. IN NO EVENT DOES THE LIMITED
WARRANTY EXTEND BEYOND THE TERMS STATED HEREIN.”

VER1212



---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Author                          : jenniferr
Comments                        : 
Company                         : 
Source Modified                 : D:20130604133559
Subject                         : 
Tagged PDF                      : No
XMP Toolkit                     : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26
Metadata Date                   : 2013:06:04 09:38:24-04:00
Creator Tool                    : Acrobat PDFMaker 10.0 for Word
Document ID                     : uuid:253ddd1c-96ac-4e21-a872-64760d94f83a
Instance ID                     : uuid:f99c4938-435f-4460-89d7-f930bedbbb9e
Format                          : application/pdf
Title                           : 
Description                     : 
Creator                         : jenniferr
Producer                        : Adobe PDF Library 10.0
Keywords                        : 
Page Layout                     : OneColumn
Page Count                      : 6
Application Record Version      : 2
By-line                         : Administrator
X Resolution                    : 96
Y Resolution                    : 96
Orientation                     : Horizontal (normal)
Resolution Unit                 : inches
Software                        : Adobe Photoshop CS4 Windows
Modify Date                     : 2013:06:03 15:38:08
Artist                          : Administrator
XP Author                       : Administrator
Date/Time Original              : 2013:05:08 15:05:57
Create Date                     : 2013:05:08 15:05:57
Sub Sec Time Original           : 75
Sub Sec Time Digitized          : 75
Color Space                     : Uncalibrated
Exif Image Width                : 695
Exif Image Height               : 491
Padding                         : (Binary data 2060 bytes, use -b option to extract)
Compression                     : JPEG (old-style)
Thumbnail Offset                : 4598
Thumbnail Length                : 0
IPTC Digest                     : 460cf28926b856dab09c01a1b0a79077
Displayed Units X               : inches
Displayed Units Y               : inches
Print Style                     : Centered
Print Position                  : 0 0
Print Scale                     : 1
Global Angle                    : 30
Global Altitude                 : 30
URL List                        : 
Slices Group Name               : Exploded diagram of DH-310 heat lamp
Num Slices                      : 1
Pixel Aspect Ratio              : 1
Photoshop Thumbnail             : (Binary data 6825 bytes, use -b option to extract)
Has Real Merged Data            : Yes
Writer Name                     : Adobe Photoshop
Reader Name                     : Adobe Photoshop CS4
Exif Byte Order                 : Big-endian (Motorola, MM)
Warning                         : IFD0 pointer references previous IFD0 directory
Create Date                     : 2013:05:08 15:05:57.75
Date/Time Original              : 2013:05:08 15:05:57.75

EXIF Metadata provided by EXIF.tools