Advance Security TR44 Car Alarm Transceiver User Manual CA Elite 6 series Install rev A 4 13 09

Advance Security Inc Car Alarm Transceiver CA Elite 6 series Install rev A 4 13 09

User manual

1ca4552. 2011 Audiovox Electronics Corporation. All rights reserved.PROFESSIONALSERIESca 4552Owner’s GuideIMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual isapplicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/ORSAFETY PRECAUTIONS may not apply. Please see your installing dealer for more information. Remote Start System
2 ca4552. 2011 Audiovox Electronics Corporation. All rights reserved.Using Your Remote Vehicle Starter Remote Starting Your VehicleThe system WILL NOT start the vehicle if any one of the followingsituations exist:1. The vehicle's hood is opened.2. The gear shift selector is not in Park.3. The brake pedal is depressed.4. Valet Mode is active.1. To start the vehicle, press and release the button 2 times within 2 seconds. Thevehicle will start and remain running for the pre-programmed 5, 10, 15, 20, 45 or60 minute run cycle. As a visual indication, the parking lights will flash or remainon depending on the setting by your installation center.2. When you arrive at the vehicle, turn the ignition key to the ON position (Do not tryto restart the vehicle), then step on the brake pedal to disengage the remote start.The vehicle will continue to run, but now on it's own power. Shutting Down the Remote StartTo shut down the remote start feature from the transmitter press and release the button 2 times within 2 seconds. Unlocking the Vehicle (optional)To unlock the vehicle's doors press and hold the button for 3 seconds anytimethe vehicle is remote started.Note: Additional parts and/or labor may be necessary, see your installing dealerfor details. Programmed Transmitter NotificationAs a security precaution each time the vehicle’s ignition is turn on the status LEDlight with flash the number of transmitters programmed into the system. This helpsto identify unauthorized transmitters from accessing your vehicle. If you believe anunauthorized transmitter has been programmed to your system, contact yourinstalling dealer for assistance.
3ca4552. 2011 Audiovox Electronics Corporation. All rights reserved.To begin the 2 / 3 hour start up timer mode:1. Turn the vehicle’s ignition ON then OFF.2. Press and hold the valet button.3. Press the button 4 times, the system will;a. When set for 3 Hour (default) - flash the parking lights 4 times.b. When set for 2 Hour - flash the parking lights 2 times.4. Release the valet button.To exit the 2 / 3 hour start up timer mode:1. Turn the vehicle’s Ignition ON.OR1. Activate the remote vehicle start feature using the remote control. Operating the 2 / 3 Hour Start Up Timer ModeThe system has the ability to start the vehicle every 2 or 3 hours for a 48 hourperiod. This feature is especially useful in cold climates where the only means tokeep the engine and engine fluids warm is to periodically start the engine. Thedefault setting is 3 hour, selection between 2 or 3 hour is made in optionprogramming.WARNING!Be certain that the vehicle is outdoors before using this or any remote startingdevice. A running engine produces dangerous carbon monoxide fumes which canbe harmful or fatal if prolonged exposure occurs. DO NOT remote start the vehicleif it is garaged. Using the “Quick-stop” FeatureIf you want to make a short stop and keep your vehicle running (to keep theinterior warm or cool), the quick-stop feature allows you to do this while keepingyour vehicle secure and your keys with you.To engage quick stop:1. Stop the vehicle and place the transmission in PARK.2. With your foot off the brake pedal, press and release the button 2times within 2 seconds. The LED will flash 3 times to confirm quickstop is entered.3. Remove the keys from the ignition and exit the vehicle. Lock thevehicle’s doors if desired.Note: Do not leave children or animals unattended in the vehicle when using thequick-stop feature.
4 ca4552. 2011 Audiovox Electronics Corporation. All rights reserved.Transmitter Button Functions1 Button Transmitter Start / Aux Operation MethodUnlock XPress and Hold - During remote start onlyRemote Start XPress and Release (1 or 2 times depending on selectable option) Remote Start Shut Down XPress and Release (1 or 2 times depending on selectable option) Valet ModeValet Mode is used to disable the system from remote starting. Toenter or exit valet mode simply follow the 4 steps outlined below:1. Turn the vehicle’s ignition ON.2. Push and hold the programming/valet button.3. The LED will turn on solid when valet mode is active4. Release the programming/valet button.2 Way Transmitter NotificationsFUNCTION BEEPS / LED FLASHESActivation 1 Beep / FlashConfirm Remote Start 4 Beeps / Flashes (repeats 3 times)Remote Start Running 1 Flash per 3 seconds for duration run timeRemote Start Shutdown 1 Long Beep / Long Flash (repeats 3 times)Low Battery 3 Beeps / Flashes when button is pressed
5ca4552. 2011 Audiovox Electronics Corporation. All rights reserved.Replacing Remote Control Batteries1 Way Remote Control: The batteries (model CR2016) inside each remote control should last approximately1 year under normal use. When the batteries become weak you will notice theremote control range (the distance from the vehicle the remote control will work)deteriorate and the small LED on the remote control will dim. To replace the remotecontrol batteries:1. Unsnap and disassemble the halves of the remote control.2. Remove the old batteries, observing the +/- symbols on the batteriesand replace with new CR2016 batteries.3. Reassemble the halves of the remote control.4. Test operation of the remote control.2 Way Remote Control: The battery (model CR2032) inside each remote control should last approximately10 months under normal use. When the battery become weak you will notice theremote control range (the distance from the vehicle the remote control will work)deteriorate and the small LED on the remote control will dim. To replace the remotecontrol battery:1. Remove 3 screws and disassemble the halves of the remote control.2. Remove the old battery, observing the +/- symbols on the batteryand replace with a new CR2032 battery.3. Reassemble the halves of the remote control and install the 3 screws.4. Test operation of the remote control.
6 ca4552. 2011 Audiovox Electronics Corporation. All rights reserved.Code Systems, Inc. Limited Lifetime WarrantyCode Systems Inc. (“CODE”) warrants to the ORIGINAL PURCHASER of this CODE vehiclesecurity product (the “Product”), purchased from an authorized CODE dealer, that (except asprovided below) should this Product under normal use and conditions, be proven defective inmaterial or workmanship DURING THE LIFETIME OF THE VEHICLE IN WHICH IT WAS ORIGI-NALLY INSTALLED, such defect(s) will be repaired or replaced (at CODE’s option) without chargefor parts directly related to repairs of the defect(s).Switches, indicator lights, and transmitter cases are similarly warranted to the original purchaserfor a period of one (1) year from the date of purchase of the Product.CODE accessories, sold separately, are covered by the applicable warranty accompanying theaccessory.This warranty is non-transferable, non-assignable and is voided when: (1) the Product is removedfrom the vehicle in which it was originally installed; or (2) the vehicle in which the Product wasoriginally installed is transferred to another party.This warranty does not apply to any product damaged by accident, physical or electrical abuse,improper installation, alteration, or use contrary to its intended function, fire, flood, or othernatural acts.In order for the Product to be repaired or replaced under the terms of this warranty, the defectiveProduct must be returned to an authorized CODE dealer and accompanied by a copy of the retailsales receipt. The date of purchase and year, make and model of the vehicle in which the Productwas originally installed must be clearly indicated on the sales receipt.This warranty is exclusive and CODE MAKES NO OTHER WARRANTIES EXPRESSED ORIMPLIED. ANY IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MER-CHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED TO THEDURATION OF THIS WRITTEN WARRANTY. IN NO CASE SHALL CODE BE LIABLE FOR ANYCONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH OF THIS OR ANY OTHERWARRANTY, EXPRESS OR IMPLIED, WHATSOEVER.CODE does not warrant that the Product cannot be compromised or circumvented. THE EXTENTOF CODE’S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACE-MENT PROVIDED ABOVE AND, IN NO EVENT SHALL CODE’S LIABILITY EXCEED THE PUR-CHASE PRICE PAID BY THE ORIGINAL PURCHASER OF THE PRODUCT WITHOUT INSTAL-LATION LABOR.Some states do not allow the exclusion or limitation of incidental or consequential damages, so theabove limitation may not apply to you. This warranty gives you specific legal rights and you mayalso have other rights which vary from state to state
7ca4552. 2011 Audiovox Electronics Corporation. All rights reserved.
8 ca4552. 2011 Audiovox Electronics Corporation. All rights reserved.Audiovox Electronics Corporation.Customer Service 1-800-421-3209WWW.CODE-ALARM.COMFCC COMPLIANCEThis device complies with Part 15 of the FCC rules and with RSS-210 ofIndustry Canada. Operation is subject to the following two conditions:1. This device may not cause harmful interference, and2. This device must accept any interference received, including any interferencethat may cause undesired operation.Warning!Changes or modifications not expressly approved by the party responsible forcompliance could void the user’s authority to operate the equipment.

Navigation menu