AirVast Technology WN113SH18 802.11b WLAN PCMCIA Card W/Detachable Antenna User Manual OEM installation guide

Download:
Mirror Download [FCC.gov]
Document ID	405093
Application ID	6ploZQSRVXmaezPMUncxxw==
Document Description	OEM installation guide
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	0.94kB (11695 bits)
Date Submitted	2004-03-15 00:00:00
Date Available	2004-03-12 00:00:00
Creation Date	2004-03-12 09:33:03
Producing Software	Acrobat PDFWriter 5.0 for Windows NT
Document Lastmod	0000-00-00 00:00:00
Document Title	OEM installation guide.doc
Document Creator	OEM installation guide - Microsoft Word
Document Author:	marklee

802.11b Wireless LAN P3 Detachable
Antenna PCMCIA Card
OEM installation guide
WN-113SH18
STATEMENT FOR MODUAL APPROVAL
For OEM integrators, the manual for the OEM integrators must include some instructions to be
followed by the end users in the user manual. For example:
The OEM integrators must be instructed to ensure that the end user has no manual instructions to
remove or install the device.
The OEM integrators must be instructed about the end product labeling ("Contains TX FCC ID:
QDWWN113SH18")
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and
2) The transmitter module may not be co-located with any other transmitter or antenna.
As long as the 2 conditions above are met, further transmitter test will not be required. However, the
OEM integrator is still responsible for testing their end product for any additional compliance
requirements required with this module installed (for example, digital device emissions, PC peripheral
requirements, etc.).
IMPORTANT NOTE: In the event that these conditions cannot be met (for example certain laptop
configurations or co-location with another transmitter), then the FCC authorization is no longer
considered valid and the FCC ID can not be used on the final product. In these circumstances, the
OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed such
that 20 cm may be maintained between the antenna and users (for example, access points, routers,
wireless ADSL modems, and similar equipment). The final end product must be labeled in a visible
area with the following: "Contains TX FCC ID: QDWWN113SH18 ".
Notice for OEM integrator
Following RF exposure info shall be supplied in end-users manual depends on the application.
For mobile configuration of RF Exposure Information:
IMPORTANT NOTE:
To comply with FCC RF exposure compliance requirements, this grant is applicable to only
Mobile Configurations. The antennas used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be co-located or operating
in conjunction with any other antenna or transmitter
For Laptop Configuration of RF Exposure information:
This device has been tested for compliance with FCC RF Exposure (SAR) limits in the typical
laptop computer configuration and this device can be used in desktop or laptop computers with
side mounted PCMCIA slots. This device cannot be used with handheld PDAs (personal digital
assistants).
This device and its antenna must not be co-located or operated in conjunction with any other
antenna or transmitter.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Page Count                      : 2
Creator                         : OEM installation guide - Microsoft Word
Create Date                     : 2004:03:12 09:33:03
Title                           : OEM installation guide.doc
Author                          : marklee
Producer                        : Acrobat PDFWriter 5.0 for Windows NT

EXIF Metadata provided by EXIF.tools