Airgo Networks AGN1202AP0000 802.11 a/b/g True MIMO Access Point User Manual regulatory info

Airgo Networks Inc. 802.11 a/b/g True MIMO Access Point regulatory info

Contents

User manual regulatory info

[Installation and User Guide]: [Access Point] 261
BRegulatory and License Information
This appendix contains the regulatory and license information specific to the [Access Point]
hardware and software.
FCC Certifications
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•Consult the dealer or an experienced radio/TV technician for help.
ID Access Point Requirement Details
CERT1 Safety UL 1950 third edition
TUV approval
UL-2043 (Fire and Smoke) Compliance
CERT2 EMC EMC Directive 89/336/EEC (CE Mark)
CERT3 Radio Approvals FCC CFR47 Part 15, section 15.247
FCC (47CFR) Part 15B, Class B Emissions
Canada IC RSS210
Japan MIC Radio Regulations
Europe: ETS 300.328
CAUTION: Any changes or modifications not expressly approved by the grantee of
this device could void the user’s authority to operate the equipment.
B Regulatory and License Information
262 [Installation and User Guide]: [Access Point]
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20cm
between the radiator and your body.

Navigation menu