Alien Technology ATRM900F01 RFID READER User Manual

Alien Technology Corporation RFID READER Users Manual

Contents

Users Manual

Alien Technology Corporation User’s Guide
User’s Guide 2 Disclaimer Alien Technology Corporation is registered trade mark of Alien Technology Corporation is registered trade mark of Alien Technology Corporation All other trademarks and trade names referred to herein are property of their respective owners. Microsoft Windows®, Windows® 2000, Windows® CE .NET, Windows® NT, and Windows® XP are registered trademarks of Microsoft Corporation. FCC Information to User This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is con-nected. • Consult the dealer or an experienced radio/TV technician for help. Caution Modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC Compliance Information : This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation IMPORTANT NOTE: FCC RF Radiation Exposure Statement: This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
User’s Guide 3Using 900MHz RFID Tag Reader Enable to equip a UHF 900Mhz Tag Reader. Enable to read and write RFID Tag which supported protocol of EPC GEN2. The Frequency range is 850MHz ~ 960MHz, and could adjustable. 3.1Executing RF900Demo Program [Start button] -> [Program] -> [DEMO Apps] -> [RF900Demo] UHF Reader Run RF900Demo Program INVENTORY Mode: Single Read: Read one Tag each time.Multi Read: Read multi Tag each time (Anti Collision). INVENTORY: Press <Inventory> button to read tags.
User’s Guide 4 Chapter5. Appendix Configuration UHF 900MHz Tag Reader Frequency 865.7MHz ~ 867.5MHz for Europe 902.75 ~ 927.25MHz for USA Reading Range 0m ~ 7m (Differs from each tag) Writing Range 0m ~ 3m Antenna Gain 2 dbi (Standard) Speed 62.5 kbps RF Output 1W EIRP Protocol EPC Gen2 ISO 18000 6C ISO 18000 6B Multi-Reading Anti collision

Navigation menu