Alpha Networks WUSN10A1 WIRELESS 150 USB ADAPTER User Manual WUS N10

Alpha Networks Inc. WIRELESS 150 USB ADAPTER WUS N10

Users Manual

Adapter Installation 1. Turn on the computer and Insert the Alpha WUS-N10 Driver CD in the CD-ROM drive 2. When the auto run screen appears, click Install Drivers. The InstallShield Wizard window will appear. 3. By default setup will install to the default location: To install to a different location click Browse and specify the location. 4. Select the Program Files folder location 5. Insert the adapter into an available USB port on your computer. 6. The Wireless Connection Wizard will now appear. 7. To connect to your network using the WPS push button configuration method, click the virtual button as shown in the screenshot. Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this
equipment. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. IEEE 802.11b or 802.11g operation of this product in the U.S.A. is firmware-limited to channels 1 through 11. Antennas must be installed to provide 20 cm separation distance from the transmitting antenna to the body of the user during normal operating condition. This device must not be co-located or operating in conjunction with any other antenna or transmitter. Only those antennas filed under FCC ID: RRKWUSN10A1 can be used with this device. When the module is installed in the final system where the antenna location is less than 20 cm separation distance to the body of user, additional equipment authorization must be applied. FCC ID label on the final system must be labeled with “Contains FCC ID: RRKWUSN10A1” or “Contains transmitter module FCC ID: RRKWUSN10A1”. In the user guide, final system integrator must be ensure that there is no instruction provided in the user guide to install or remove the transmitter module. The transmitter module must be installed and used in strict accordance with the manufacturer's instructions as described in the user documentation that comes with the product. This device complies with the following radio frequency and safety standards.

Navigation menu