Alpheus Digital DW3-101 Door Windows Sensor User Manual

Alpheus Digital Co., Limited. Door Windows Sensor

User Manual

Door Window Sensor The DW3-101 is a Contact Sensor intended for doors, windows, and numerous other objects that open and close. Each Door Sensor has two pieces - the contact sensor (large piece) and the magnet (small piece). The sensor sends a signal to the control panel when the magnet is moved away from or near the contact sensor. The sensor will also send a signal when the contact sensor cover is tampered. Adding Sensor to the Panel To add a Door Window sensor to the panel, set your panel to sensor learning mode, tamper the sensor by removing the sensor cover and replacing it then exit program mode. Installation To Install an DW3-101 on a door, place the magnet on the top corner of the door, opposite the hinge on the flattest surface. Place the contact sensor no more than 3 inches to the side or above the magnet on the molding. Press firmly and hold it in place for 30 seconds. If you have crown molding or another decorative molding, it might be better to reverse the setup (contact sensor on door, magnet on molding).Be sure to align the two half circles on the contact sensor and magnet when you install them. To Install an DW3-101 on a window, place the magnet in the middle of the window frame on the right or left side. Place the contact sensor on the window molding. Be sure to align the two half circles on the contact sensor and magnet when you install them. Press firmly and hold it in place for 30 seconds. Reverse the contact sensor and magnet if necessary. Testing To test an DW3-101 sensor, go to test mode on your panel and ensure the panel volume is loud enough to hear. Next, move the magnet piece away from the contact sensor (large piece). Listen for the appropriate verification sounds (see panel instructions for more details). When you are finished, Exit test mode. Battery Installation/Replacement To install or replace batteries in the DW3-101, open the contact sensor (large piece) by finding the small side with three vertical lines. Insert your fingernail or a flat head screwdriver into the hole and pull the cover toward you. The Sensor requires two CR2032 batteries. Insert the batteries with the “+” facing toward you. Replace the cover starting with the small side without three vertical lines. You should hear a click when the cover is properly replaced. Specifications Signal Range: 100m Open air Frequency: 345.00 MHz Supervisory Interval: 60 minutes Operating Temperature: 0-49℃ Operating Humidity: 5-90% Non-Condensing Battery Type: CR2025 FCC COMPLIANCE STATEMENT* This device complies with FCC Rules and Regulations as Part 15 devices. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation. FCC ID:OC7DW3-101 Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help.

Navigation menu