Alpheus Digital DW3-101 Door Windows Sensor User Manual
Alpheus Digital Co., Limited. Door Windows Sensor
User Manual
Door Window Sensor
The DW3-101 is a Contact Sensor intended for doors,
windows, and numerous other objects that open and close.
Each Door Sensor has two pieces - the contact sensor (large
piece) and the magnet (small piece). The sensor sends a signal
to the control panel when the magnet is moved away from or
near the contact sensor. The sensor will also send a signal
when the contact sensor cover is tampered.
Adding Sensor to the Panel
To add a Door Window sensor to the panel, set your panel to
sensor learning mode, tamper the sensor by removing the
sensor cover and replacing it then exit program mode.
Installation
To Install an DW3-101 on a door, place the magnet on the top
corner of the door, opposite the hinge on the flattest surface.
Place the contact sensor no more than 3 inches to the side or
above the magnet on the molding. Press firmly and hold it in
place for 30 seconds.
If you have crown molding or another decorative molding, it
might be better to reverse the setup (contact sensor on door,
magnet on molding).Be sure to align the two half circles on
the contact sensor and magnet when you install them.
To Install an DW3-101 on a window, place the magnet in the
middle of the window frame on the right or left side.
Place the contact sensor on the window molding. Be sure to
align the two half circles on the contact sensor and magnet
when you install them. Press firmly and hold it in place for 30
seconds. Reverse the contact sensor and magnet if necessary.
Testing
To test an DW3-101 sensor, go to test mode on your panel
and ensure the panel volume is loud enough to hear. Next,
move the magnet piece away from the contact sensor (large
piece). Listen for the appropriate verification sounds (see
panel instructions for more details). When you are finished,
Exit test mode.
Battery Installation/Replacement
To install or replace batteries in the DW3-101, open the
contact sensor (large piece) by finding the small side with
three vertical lines. Insert your fingernail or a flat head
screwdriver into the hole and pull the cover toward you. The
Sensor requires two CR2032 batteries. Insert the batteries
with the “+” facing toward you. Replace the cover starting
with the small side without three vertical lines. You should
hear a click when the cover is properly replaced.
Specifications
Signal Range: 100m Open air
Frequency: 345.00 MHz
Supervisory Interval: 60 minutes
Operating Temperature: 0-49℃
Operating Humidity: 5-90% Non-Condensing
Battery Type: CR2025
FCC COMPLIANCE STATEMENT*
This device complies with FCC Rules and Regulations as Part
15 devices.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired operation.
FCC ID:OC7DW3-101
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician
for help.