Alpheus Digital MP-101 Medical Pendant Sensor User Manual use manual 20170926 MP 101

Alpheus Digital Co., Limited. Medical Pendant Sensor use manual 20170926 MP 101

User Manual

Medical Pendant The MP-101 ’s main purpose is to send emergency signals to the System regardless if the System is armed or disarmed. To trigger the Medical Pendant and send emergency signals to the Central Monitoring Station, press the Medical Pendant Help button in the center of the device for at least 2 seconds. Adding a Pendant to the Panel To add a MP-101 to the panel, set your panel to sensor learning mode, tamper the sensor by pressing the test button found on the side of the sensor. Testing To test a MP-101 go to test mode on your panel and ensure the panel volume is loud enough to hear. Press the Help button on the center of the Medical Pendant and hold it for at least 2 seconds. When you are finished, Exit test mode. Battery Installation/Replacement To change the Medical Pendant battery, remove the bottom cover by using a small Phillips-head screwdriver to remove the four screws. The medical pendant requires 1 CR2032 lithium-ion battery. When installing the new battery make sure the + sign is facing out. Replace the cover and tighten the 4 screws. Specifications Signal Range: 100m Open Air Frequency: 345.00 MHz Operating Temperature: 32°F-120°F Operating Humidity: Water Proof IPX7 Battery Type: CR2032 FCC COMPLIANCE STATEMENT* This device complies with FCC Rules and Regulations as Part 15 devices. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation. FCC ID:OC7MP-101 Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help.

Navigation menu