Alpheus Digital MP-101 Medical Pendant Sensor User Manual use manual 20170926 MP 101
Alpheus Digital Co., Limited. Medical Pendant Sensor use manual 20170926 MP 101
User Manual
Medical Pendant
The MP-101 ’s main purpose is to send emergency signals to
the System regardless if the System is armed or disarmed. To
trigger the Medical Pendant and send emergency signals to
the Central Monitoring Station, press the Medical Pendant
Help button in the center of the device for at least 2 seconds.
Adding a Pendant to the Panel
To add a MP-101 to the panel, set your panel to sensor
learning mode, tamper the sensor by pressing the test button
found on the side of the sensor.
Testing
To test a MP-101 go to test mode on your panel and ensure
the panel volume is loud enough to hear. Press the Help
button on the center of the Medical Pendant and hold it for at
least 2 seconds. When you are finished, Exit test mode.
Battery Installation/Replacement
To change the Medical Pendant battery, remove the bottom
cover by using a small Phillips-head screwdriver to remove the
four screws. The medical pendant requires 1 CR2032 lithium-
ion battery. When installing the new battery make sure the +
sign is facing out. Replace the cover and tighten the 4 screws.
Specifications
Signal Range: 100m Open Air
Frequency: 345.00 MHz
Operating Temperature: 32°F-120°F
Operating Humidity: Water Proof IPX7
Battery Type: CR2032
FCC COMPLIANCE STATEMENT*
This device complies with FCC Rules and Regulations as Part
15 devices.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired operation.
FCC ID:OC7MP-101
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician
for help.