Altis Technology B150 Speaker User Manual Quick start manual of BBY set up

Download:
Mirror Download [FCC.gov]
Document ID	3354609
Application ID	gyRmfWynZRIseGYvcY4IPg==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	6.61kB (82664 bits)
Date Submitted	2017-04-12 00:00:00
Date Available	2017-04-12 00:00:00
Creation Date	2017-03-30 19:38:27
Producing Software	Acrobat Distiller 9.0.0 (Windows)
Document Lastmod	2017-03-30 19:38:27
Document Title	Microsoft Word - Quick start manual of BBY set up
Document Creator	PScript5.dll Version 5.2.2
Document Author:	Administrator

User guide
Product Name: Speaker
Model Name : B150
1. Unscrew the Bluetooth module by turning counterclockwise (Pic 1 & 2). Take
out the battery holder andinsert 4 AA alkaline or rechargeable batteries (Pic 3 &
4).
2.
Position batteries according to polarity marking (Pic. 1) , and screw the
Bluetooth module by turning clockwise (Pic 2).
3.
To turn the Flashlight on, pull the globe and press the “M” button, the flashlight
will always turn on at the brightest setting with the lantern mode. Hold the “M”
button down can dim or brighten. The light will flash twice at the lowest /
brightest level.
4.
To enable flashlight mode, collapse the globe.
5.
Press and hold the “ON/OFF” button for 2 to 3 seconds to switch on the
Bluetooth module. The Bluetooth module will poweron (Bluetooth name: B150)
Voice reminder after the Bluetooth being activated:
1. When the Bluetooth module is on, voice indicator will say“Hello, This
system is ON. Enter pairing mode”.
2. When pairing is completed, the voice indicator will say “Connected”.
3. When it is disconnected, the voice indicator will say “Disconnected, Enter
pairing mode”.
4. When the Bluetooth cannot be connected successfully, the voice indicator
will say “Enter pairing mode”.
5. Press and hold the “ON/OFF” button again to switch off the Bluetooth
module, the voice indicator will say “Bye Bye”.
6. When the battery is low, the voice indicator will say “Low Battery”.
If the Bluetooth module did not pair with any devices, the voice indicator will
say “Enter pairing mode” every 3 minutes until the module is paired.
If the Bluetooth module cannot pair with any devices within 15 minutes, the
voice indicator will say “Bye Bye” and switch off the unit automatically.
6. To disconnect the Bluetooth connection by holding the “ON/OFF” button for 2
seconds.
7. When the Flashlight / Bluetooth at low battery level, the voice indicator will
say “Low Battery” to remind the unit needs to be re‐charged.
8. To remove the USB charger cover and connect with the USB cable to charge
the unit. The unit is charging if the green / red light flashing alternatively. For
example, it will take around 7 hours to fully re‐charge a 1300mAh and the
green light is on when the unit is being fully charged.
1. To unscrew the existing module by turning counterclockwise and replace the
“Emergency Power Bank” unit.
2. To remove the cover of the USB charging port and press “ON/OFF” (Pic. 1)
green light is on if power output is in order (Pic. 2). To press “ON/OFF”
button again to turn off the power output.
3. Emergency Power Bank can work independently. Green light will flash (Pic. 1)
when charging the phone. When the Emergency Power Bank at low battery
level, green / red light will flash alternatively (Pic. 2) to reminder user to re‐
charge the unit.
4. The red light will on (Pic. 1) when the Emergency Power Bank is being
charged, the green light will on (Pic. 2) when it is fully charged.
5. When the Flash light use together with the Emergency Power Bank, the red
light on the USB charging port will flash to indicate the low battery level and
the unit need to be re‐charged.
warning statement
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Author                          : Administrator
Create Date                     : 2017:03:30 19:38:27+08:00
Modify Date                     : 2017:03:30 19:38:27+08:00
XMP Toolkit                     : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00
Creator Tool                    : PScript5.dll Version 5.2.2
Producer                        : Acrobat Distiller 9.0.0 (Windows)
Format                          : application/pdf
Title                           : Microsoft Word - Quick start manual of BBY set up
Creator                         : Administrator
Document ID                     : uuid:d18ad4aa-7241-49c4-ba18-eb44913da41e
Instance ID                     : uuid:ee02a6ed-0762-4f46-a2fd-5048f72751e2
Page Count                      : 2

EXIF Metadata provided by EXIF.tools