Apc Smart Ups 2200 Xl Users Manual SU IM 990 4651A 002 MN01 EN

3000 XL to the manual 151e060a-2364-4740-a5dd-b37d45626319

: Apc Apc-Smart-Ups-2200-Xl-Users-Manual-470884 apc-smart-ups-2200-xl-users-manual-470884 apc pdf

Open the PDF directly: View PDF .
Page Count: 10

Installation Guide Smart-UPS™ X

2000/2200/3000 XL Tower/Rack-Mount 4U

Important Safety Messages

Read the instructions carefully to become familiar with the equipment before trying to install, operate,

service or maintain it. The following special messages may appear throughout this manual or on the

equipment to warn of potential hazards or to call attention to information that clarifies or simplifies a

procedure.

The addition of this symbol to a Caution product safety label indicates that a hazard exists that can result in

injury and product damage if the instructions are not followed.

The following safety messages may appear throughout this manual to warn of potential hazards.

Safety and General Information

Inspect the package contents upon receipt. Notify the carrier and dealer if there is any

damage.

Read the Safety Guide supplied with this unit before installing the UPS.

• Adhere to all local and national electrical codes.

• This UPS is intended for indoor use only.

• Do not operate this UPS in direct sunlight, in contact with fluids, or where there is excessive dust or

humidity.

• Be sure the air vents on the UPS are not blocked. Allow adequate space for proper ventilation.

• The battery typically lasts for two to five years. Environmental factors impact battery life. Elevated

ambient temperatures, poor quality utility power, and frequent short duration discharges will shorten

battery life.

• Connect the UPS power cable directly to a wall outlet. Do not use surge protectors or extension cords.

• The batteries are heavy. Remove the batteries prior to installing the UPS in a rack.

• Always install external battery packs (XLBPs) at the bottom of the rack. The UPS must be installed

above the XLBPs.

• The UPS display interface will recognize as many as 10 external battery packs connected to the UPS.

However there is no limit to the number of XLBPs that can be used with the UPS.

• Refer to Specifications in the Operation manual for UPS and battery weight.

CAUTION

CAUTION indicates a potentially hazardous situation which, if not avoided, can result in equipment damage and minor or

moderate injury.

CAUTION

CAUTION indicates a potentially hazardous situation which, if not avoided, can result in equipment damage.

Smart-UPS X 2000/2200/3000 VA XL Tower/Rack-Mount 4U2

Inventory

Inspect the contents upon receipt. Notify the carrier and dealer if the unit is damaged.

Included with all models

1 pair rail cleats

8 pan head screws 1 pair tower stabilizer brackets

Use 8 flat head screws to secure tower stabilizer brackets to the UPS

1 pair rack-mount brackets

Use 8 flat head screws to secure rack-mount brackets to the UPS

Use 4 ornamental screws to secure rack-mount brackets to the rails

Install a cage nut in the rack to secure the top hole of each rack-mount

bracket in a four post rack

(1) Documentation CD

(1) PowerChute software CD

Rack-mount support brackets and hardware Included with models that have factory installed

Network Management Cards

1 pair support

brackets

Two post racks

10 screws Four post racks

6 screws

6 washers

Included with High Voltage (HV) models

Smart-UPS X 2000/2200/3000 VA XL Tower/Rack-Mount 4U 3

Product Overview

Front panel features

Rear panel features

1Online LED

2Power ON/OFF button

3On Battery LED

4Site Wiring Fault LED

5Replace Battery LED

6LCD display screen

7UP/DOWN arrow keys

8ENTER key

9ESC key

1SmartSlot 7Controllable Outlet Group 3

2Chassis ground screw 8External battery pack connector

3UPS utility power input 9EPO connector

4Circuit Breaker reset :Serial port

5Controllable Outlet Group 1 ;USB port

6Controllable Outlet Group 2

2000 VA, 120 Vac Low Voltage 3000 VA, 120 Vac Low Voltage

su0343a

APC b

y

Schneider

Electric

su0756a

GROUP 1GROUP 2

GROUP 3

su0757a

Smart-UPS X 2000/2200/3000 VA XL Tower/Rack-Mount 4U4

Remove Battery

2200/3000 VA, 230 Vac High Voltage 3000 VA, 208 Vac High Voltage

CAUTION

DAMAGE TO EQUIPMENT OR PERSONNEL

• The equipment is heavy. Always practice safe lifting techniques adequate for the weight of the equipment.

• The UPS + the battery weighs 41 kg (90.4 lb).

• The battery weighs 23.8 kg (52.4 lb). Remove the battery before installing the unit in a rack.

• Use the battery handle to lift and slide the battery out of the UPS.

Failure to follow these instructions can result in equipment damage and minor or moderate injury

123

GROUP 2

GROUP 3

GROUP 1

su0755a

su0754a

GROUP 1 GROUP 3GROUP 2

su0758a

su0759a

s

u

0

7

6

0

a

Smart-UPS X 2000/2200/3000 VA XL Tower/Rack-Mount 4U 5

Tower Configuration

12

34

5

su0761a

su0763a

su0764a

su0774a

su0762a

Smart-UPS X 2000/2200/3000 VA XL Tower/Rack-Mount 4U6

Rack-Mount Configuration

Tower to rack-mount conversion

CAUTION

DAMAGE TO EQUIPMENT OR PERSONNEL

• The equipment is heavy. Always practice safe lifting techniques adequate for the weight of the equipment.

• The UPS + the battery weighs 41 kg (90.4 lb).

• The battery weighs 23.8 kg (52.4 lb). Remove the battery before installing the unit in a rack.

• Use the battery handle to lift and slide the battery out of the UPS.

Failure to follow these instructions can result in equipment damage and minor or moderate injury

12

34

56

su0764b

su0763b

su0583b

su0761b

su0766a

su0769a

Smart-UPS X 2000/2200/3000 VA XL Tower/Rack-Mount 4U 7

Two post rack installation

CAUTION

DAMAGE TO EQUIPMENT OR PERSONNEL

• When installing equipment in a rack, always install external battery packs at the bottom of the rack.

• The UPS should always be installed above the external battery packs in rack or stack configurations.

Failure to follow these instructions can result in equipment damage and minor or moderate injury

123

456

su0776a

su0768a

su0

770a

su0771a

su0773a

su0772a

Smart-UPS X 2000/2200/3000 VA XL Tower/Rack-Mount 4U8

Four post rack installation

Use an APC by Schneider Electric four post rail kit. To order the rail kit go to the APC by Schneider Electric

Web site apc.com.

UPS Configuration

Connect Emergency Power Off feature

For instructions on how to connect the Emergency Power Off (EPO) switch, refer to the Operation and

Maintenance manual on the Documentation CD (supplied).

Configure controllable outlet groups

The outlets on the UPS are configured into groups. To utilize the controlled outlet features, use the

Advanced menus on the display interface and navigate to: Main Menu > Control > Outlet1 Control.

123

45

67

su0777a

su0778a

su0779a

su0780a

su0781a

su0782a

Smart-UPS X 2000/2200/3000 VA XL Tower/Rack-Mount 4U 9

Electrical connections

CAUTION

RISK OF EQUIPMENT DAMAGE

• Adhere to all local and national electrical codes.

• Wiring should be performed by qualified electrician.

• Always connect the UPS to a grounded outlet.

Failure to follow these instructions can result in equipment damage

Electronic Device

su0788a

UPS

Electronic Device

© 2013 APC by Schneider Electric. APC, the APC logo, Smart-UPS and PowerChute are owned by

Schneider Electric Industries S.A.S., or their affiliated companies. All other trademarks are property of

their respective owners. EN 990-4651A-002

03/2013

Select models are ENERGY STAR® qualified.

For more information go to www.apc.com/site/recycle/index.cfm/energy-efficiency/energy-star/