Apple MacPro(Early2008) Mac Pro (Early 2008) Memory (FB DIMM) DIY Replacement Instructions User Manual Pro(Early2008)Memory(FB DIMM)DIYReplacement Early2008 DIMM
User Manual: Apple MacPro(Early2008) MacPro(Early2008)Memory(FB-DIMM)DIYReplacementInstructions
Open the PDF directly: View PDF 
.
Page Count: 6
| Download | |
| Open PDF In Browser | View PDF |
Mac Pro Memory (FB-DIMM) Replacement Instructions Follow the instructions in this document carefully. Failure to follow these instructions could damage your equipment and void its warranty. The Mac Pro (Early 2008) computer has two memory riser cards with a total of 8 memory slots. On each card, the slots are arranged as two banks of two slots each. The computer comes with a minimum of 2 GB of memory, installed as a pair of 1 GB fully buffered, dual inline memory modules (FB-DIMMs) in two of the DIMM slots. Additional pairs of 1 GB, 2 GB, or 4 GB FB-DIMMs can be installed in the open DIMM slots, as illustrated below. Maximum memory is 32 GB. DIMMs must be installed as pairs of identical size and type, from the same vendor. In the illustration below, like-colored DIMMs must match. © 2008 Apple Inc. All rights reserved. 073-1179 Rev. B 1 DIMMs for Mac Pro (Early 2008) must fit these specifications: • 800 MHz, DDR2, FB-DIMMs • 72-bit wide, 240-pin modules • 36 memory ICs maximum per DIMM • Error-correcting code (ECC) Memory from older Macintosh computers is not compatible with Mac Pro (Early 2008). Important: For proper operation of Mac Pro (Early 2008) computers, Apple recommends using only Apple-approved Mac Pro (Early 2008) FB-DIMMs. Tools Required No tools are required for this procedure. Opening the Computer 1. Shut down the computer. Warning: Always shut down the computer before opening it to avoid damaging its internal components or the components you are installing. Do not open the computer or attempt to install items inside it while it is on. 2. Wait 5 to 10 minutes to allow the computer’s internal components to cool. Warning: After you shut down the system, the internal components can be very hot. You must let the computer cool down before continuing. 3. Unplug all external cables from the computer except the power cord. 4. Touch the metal PCI access covers on the back of the computer to discharge any static electricity from your body. Important: Always discharge static before you touch any parts or install any components inside the computer. To avoid generating static electricity, do not walk around the room until you have finished working and closed the computer. © 2008 Apple Inc. All rights reserved. 073-1179 Rev. B 2 5. Unplug the power cord. 6. Hold the side access panel and lift the latch on the back of the computer. Warning: The edges of the access panel and the enclosure can be sharp. Be very careful when handling them. 7. Remove the access panel and place it on a flat surface covered by a soft, clean cloth. © 2008 Apple Inc. All rights reserved. 073-1179 Rev. B 3 Removing the Installed FB-DIMM 1. Carefully lay the computer on its side so that the open side faces up. 2. Locate the FB-DIMMs. 3. Holding the memory riser card by the two finger holes, pull it out of the memory cage and place the card DIMM-side-up on a soft, clean cloth. © 2008 Apple Inc. All rights reserved. 073-1179 Rev. B 4 4. Open the ejectors on the DIMM slot by pushing them out to the sides, and remove the DIMM from the riser card. Installing the Replacement FB-DIMM Warning: FB-DIMMs carry heatsinks on either side of the DIMM. Never attempt to remove the heatsinks from the DIMMs. Doing so could damage the DIMM. 1. Align the DIMM in the slot on the riser card and push both ends of the DIMM down until the ejectors snap back up into place. © 2008 Apple Inc. All rights reserved. 073-1179 Rev. B 5 2. Insert the replacement riser card into position in the memory cage, pushing slightly until the card is seated in its logic board memory slot. Closing the Computer 1. Replace the access panel. Note: Make sure the latch is in the up position before replacing the access panel. If the latch is down, the access panel will not seat correctly in the enclosure. 2. Push the latch down to close and secure the access panel. Warning: Never turn on the computer unless all of its internal and external parts are in place and it is closed. Operating the computer when it is open or missing parts can damage it or cause injury. Apple Inc. © 2008 Apple Inc. All rights reserved. This document is protected under U.S. Copyright Law and International Treaties, and no part of this document may be reproduced in any form without written permission from Apple. Apple is not responsible for typographical, printing, or inadvertent errors. Apple Inc. 1 Infinite Loop Cupertino, CA 95014-2084 USA + 1 408 996 1010 www.apple.com Apple, the Apple logo, and Mac are trademarks of Apple Inc., registered in the U.S. and other countries. © 2008 Apple Inc. All rights reserved. 073-1179 Rev. B 6
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : No Warning : Invalid secondary xref table Tagged PDF : Yes XMP Toolkit : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:08:23 Create Date : 2008:03:10 16:01:17-07:00 Metadata Date : 2008:03:10 16:03:26-07:00 Modify Date : 2008:03:10 16:03:26-07:00 Creator Tool : Adobe InDesign CS3 (5.0.2) Thumbnail Format : JPEG Thumbnail Width : 256 Thumbnail Height : 256 Thumbnail Image : (Binary data 11294 bytes, use -b option to extract) Instance ID : uuid:388be743-87f4-4f4a-b28d-e7fc77539813 Document ID : adobe:docid:indd:7f609bf4-f04d-11dc-9c1a-93de40ab5a9a Rendition Class : proof:pdf Derived From Instance ID : 23ab1fa4-f044-11dc-9c1a-93de40ab5a9a Derived From Document ID : adobe:docid:indd:21494e58-a4bb-11dc-8bd5-cb72a13f8fef Manifest Link Form : ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream Manifest Placed X Resolution : 72.00, 180.00, 180.00, 180.00, 180.00, 180.00, 180.00 Manifest Placed Y Resolution : 72.00, 180.00, 180.00, 180.00, 180.00, 180.00, 180.00 Manifest Placed Resolution Unit : Inches, Inches, Inches, Inches, Inches, Inches, Inches Manifest Reference Instance ID : uuid:F2D5D52EB2EDDC118FE5D140B0313072, uuid:cc8c8a36-2540-11db-9b0e-bf9eeaf31746, uuid:563ecd02-14e8-11db-8f29-b4d6d445278e, uuid:0cde852d-982f-11dc-98e7-ee14167d10a4, uuid:5614ab86-9830-11dc-98e7-ee14167d10a4, uuid:86e91b6c-9855-11dc-989f-e380eec5fd82, uuid:2bf393d9-9857-11dc-989f-e380eec5fd82 Manifest Reference Document ID : uuid:F1D5D52EB2EDDC118FE5D140B0313072, adobe:docid:photoshop:7d3bf87e-253f-11db-9b0e-bf9eeaf31746, adobe:docid:photoshop:092ae8e4-14e8-11db-8f29-b4d6d445278e, adobe:docid:photoshop:0cde8526-982f-11dc-98e7-ee14167d10a4, adobe:docid:photoshop:71fae785-982f-11dc-98e7-ee14167d10a4, adobe:docid:photoshop:86e91b66-9855-11dc-989f-e380eec5fd82, adobe:docid:photoshop:2bf393d4-9857-11dc-989f-e380eec5fd82 Format : application/pdf Producer : Adobe PDF Library 8.0 Trapped : False Page Count : 6 Creator : Adobe InDesign CS3 (5.0.2) Title : Mac Pro (Early 2008) Memory (FB-DIMM) DIY Replacement Instructions Keywords : kmanual, kmpEXIF Metadata provided by EXIF.tools