Applied Wireless Identifications Group MR1824A Proximity Reader Transceiver User Manual Credit Application

Download:
Mirror Download [FCC.gov]
Document ID	700412
Application ID	Wqi1MgXWbWG9nM3OedAZuQ==
Document Description	User Manual 2 of 2
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	26.9kB (336238 bits)
Date Submitted	2006-08-31 00:00:00
Date Available	2006-08-31 00:00:00
Creation Date	2006-08-23 13:34:30
Producing Software	Acrobat Distiller 5.0.5 (Windows)
Document Lastmod	2006-08-23 13:34:41
Document Title	Credit Application
Document Creator	Acrobat PDFMaker 5.0 for Word
Document Author:	User

APPLIED WIRELESS ID
Applied Wireless Identifications Group, Inc.
382 Route 59 - Section 292, Monsey NY 10952 • Tel: 845-369-8800 • Fax: 845-369-1195
Instructions
PS12-1A POWER MODULE – INSTALLING FERRITE CLAMPS
To meet the requirements of the FCC, AWID supplies two “ferrite clamps” for installation
on all PS12-1A plug-in power module. These clamps can be installed by hand, easily and quickly,
at the site, without removing the reader or its wiring. This procedure may be used on a power
module that was installed earlier, or on one being newly installed.
1.
Locate the PS12-1A power module and its cable that connects to the LR-911 long-range reader.
2.
Arrange for enough excess cable length so that the cable can loop through both clamps.
3.
Hold the open clamp (Figure 1) at the cable as close to the PS12-1A as possible.
4.
Loop the cable once around the channel in the ferrite. Pull the cable loop tightly around the
ferrite clamp.
5.
Press the ferrite clamp around the cable until the latch at one end of the clamp snaps over the
ears on the other end of the clamp. (See Figure 2.)
Figure 1. Ferrite clamp (open).
Figure 2. 2 ferrite clamps locked on cable.
Notes: If it is necessary to remove the ferrite clamp from the cable, insert a fingernail under the latch
and lift it off the ears. The clamp will then swing open.
The PS12-1A is the power supply that AWID supplies in the LRIN Installation Kit for testing.
The PS12-1A may also be used to power the LR-911 reader permanently. In both cases the installer
must assemble the ferrite clamps to the PS12-1A’s cable.
L.H.H. 25Jul‘06

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Modify Date                     : 2006:08:23 13:34:41-03:00
Create Date                     : 2006:08:23 13:34:30-04:00
Page Count                      : 1
Creation Date                   : 2006:08:23 17:34:30Z
Mod Date                        : 2006:08:23 17:34:30Z
Producer                        : Acrobat Distiller 5.0.5 (Windows)
Author                          : User
Metadata Date                   : 2006:08:23 17:34:30Z
Creator                         : User
Title                           : Credit Application
Page Mode                       : UseNone
Tagged PDF                      : Yes

EXIF Metadata provided by EXIF.tools