Authinx AT14A WIRELESS SENDER User Manual AK14A booklet pmd

Download:
Mirror Download [FCC.gov]
Document ID	627575
Application ID	QBTjcRcPqRG7uVuDRJ/ceA==
Document Description	USERS MANUAL
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	13.54kB (169228 bits)
Date Submitted	2006-02-10 00:00:00
Date Available	2006-02-09 00:00:00
Creation Date	2006-01-19 11:50:00
Producing Software	Acrobat Distiller 5.0 (Windows)
Document Lastmod	2006-01-19 11:50:00
Document Title	AK14A-booklet.pmd
Document Creator	PageMaker 7.0
Document Author:	Dave Rye

Introduction
Send music from your MP3 player to your stereo – without any wires. The
iParty® Wireless Sender plugs into the headphone socket on your MP3 player.
There’s a rechargeable battery in the iParty Wireless Sender (so it doesn’t drain
your MP3 player’s battery). You can charge the battery by removing it from the
Sender and placing it in the compartment in the Receiver.
1. Push open the battery
compartment on the
iParty Wireless Sender.
2. Insert the supplied rechargeable
battery. Observe polarity. Replace
only with NiMH AAA 1.2V,
800 mAh rechargeable battery.
Connecting up the Receiver
The Wireless Receiver connects to your Stereo Receiver, or any audio
component that has an Audio or AUX input. You can then sit back in your easy
chair, up to 50 ft. away from your stereo, and send your music from your MP3
player to your stereo – without any wires!
6. Set the Channel Switch to
match the setting on your
iParty Wireless Sender.
AUDIO IN
Stereo
DC 12V
CHANNEL
AUDIO OUT
7. Connect the included plug-in
power supply to the Wireless
Receiver and plug the power
supply into an AC outlet near
your stereo
8. Attach the Wireless Receiver to your
stereo’s Audio or AUX input using
the supplied RCA audio cable.
Lift the Antenna
Plugs into your MP3
Player's headphone jack
9. Extend the antenna and point it in
the general direction that you
intend to listen to your music from.
3. Attach your MP3 Player to the iParty Wireless
Sender.
4. Set the iParty Sender’s Channel Switch to match
the setting on your iParty Receiver.
5. Move the Sender’s ON-OFF switch to ON.
10. When the battery in your iParty Sender
goes flat, you can charge it by inserting it
into the compartment in the Receiver. Keep
a spare battery charging in the Receiver so
you can swap the batteries when the one in
your iParty Sender needs to be charged.
The battery should last about 6 hours.
FCC Caution
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
iParty ®
Wireless Extender
Works with any MP3 Player
Model AK14A
(AT14A + AR13A)
This equipment generates and uses radio frequency energy, and if not installed and used
properly, that is, in strict accordance with the manufacturers instructions, it may cause
interference to radio and television reception. It has been type tested and found to comply with
the limits for remote control devices in accordance with the specifications in Sub-Parts B and
C of Part 15 of FCC Rules, which are designed to provide reasonable protection against such
interference in a residential installation. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause interference to radio or
television reception, which can be determined by unplugging the equipment, try to correct the
interference by one or more of the following measures.
•
•
•
•
Reorient the antenna of the radio/TV experiencing the interference.
Relocate the equipment with respect to the radio/TV.
Move the equipment away from the radio/TV.
Plug the equipment into an outlet on a different electrical circuit from the radio/TV
experiencing the interference.
• If necessary, consult your local dealer for additional suggestions.
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority
to operate the equipment.
AT14A
Wireless
Sender
MP3 Player
not included
X10 Wireless Technology, Inc. Limited One Year Warranty
X10.com, a division of X10 Wireless Technology, Inc. (X10) warrants X10 products to be free
from defective material and workmanship for a period of one (1) year from the original date of
purchase at retail. X10 agrees to repair or replace, at its sole discretion, a defective X10 product
if returned to X10 within the warranty period and with proof of purchase. If service is required
under this warranty: Call 1-800-442-5065, visit www.x10.com, or e-mail support@x10.com.
For help or more information on setup, please visit:
http://www.x10.com/support
X10.com, a division of X10 Wireless Technology, Inc.
3824 North 5th St., Suite C,
North Las Vegas, NV 89032
AK14A-01/06
AR13A
Wireless
Receiver

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Create Date                     : 2006:01:19 11:50:00-08:00
Modify Date                     : 2006:01:19 11:50:00-08:00
Page Count                      : 2
Creation Date                   : 2006:01:19 19:50:00Z
Mod Date                        : 2006:01:19 19:50:00Z
Producer                        : Acrobat Distiller 5.0 (Windows)
Author                          : Dave Rye
Metadata Date                   : 2006:01:19 19:50:00Z
Creator                         : Dave Rye
Title                           : AK14A-booklet.pmd

EXIF Metadata provided by EXIF.tools