Axia Innovations VCM7130V01 RF module-2.4G transceiver User Manual 1

Download:
Mirror Download [FCC.gov]
Document ID	3932507
Application ID	vQjk/Ki7/WGc0sJL/6JjGA==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	58.04kB (725524 bits)
Date Submitted	2018-07-20 00:00:00
Date Available	2018-07-20 00:00:00
Creation Date	2018-01-03 12:08:16
Document Lastmod	2018-07-19 12:01:50
Document Title	1
Document Creator	WPS Office
Document Author:	andy

RF module-2.4G transceiver
Model: JM7130S20PL
1.0 General Description
The JM7130S20PL module is designed for 2.4GHz ISM band wireless applications
using GFSK transceiver. This module features a fully programmable frequency
synthesizer by SPI. The data rate is 4Mbps.
2.0 Electrical specification
Item
Specification
Supply Voltage
3.3V
Current Consumption
<10uA (typical) @Sleep mode
Remark
+/-0.1V
2.5mA (typical) @Standby mode
200mA (typical) @Tx mode
26mA (typical) @Rx mode
Frequency
2400 – 2483.5MHz
ISM band
Rx Sensitivity
-90dBm (typical) @ 4M mode, Dev = 1MHz
Modulation
GFSK
Dimension
23 (L) x 21.5(W) x 4.2(H) mm
(+/-0.5mm)
Typical,
BER≦1E-3,
With Gaussian filter.
- With External Crystal
- Without connector
Crystal Frequency
16MHz +/-20ppm
Operating Temperature
-20 ~ +70°C
V1 Dec-2017
Jess Technology Co., Ltd.
1/8
3.0 Module Picture
Top view
V1 Dec-2017
Jess Technology Co., Ltd.
2/8
4. Typical application
V1 Dec-2017
Jess Technology Co., Ltd.
3/8
5. Installation instructions
We recommend placing the module on the edge or corner of the PCB board. It is best to reserve a space of 6×18mm
on the board for antenna. As shown below:
V1 Dec-2017
Jess Technology Co., Ltd.
4/8
Top view
4. Mechanical Dimension
Side View
V1 Dec-2017
Jess Technology Co., Ltd.
5/8
5. Interface
Pin
No.
Pin name
Comment
Note
REGI33
CKO
GIO2
GIO1
RF module supply voltage input
Clock output of A7130
General Purpose I/O 2
General Purpose I/O 1
SDIO
SCK
SCS
TX SW
SPI Data I/O
SPI Clock
SPI Chip Selection
RF front end PA/LNA select
10
11
RX SW
GND
X’tal in
RF front end PA/LNA select
GND
Clock in for A7130
3.3V
Active
low
Active
low
6. PA & LNA control state
Control function
TX SW
RX SW
V1 Dec-2017
RX ON
TX ON
TR/X OFF
Jess Technology Co., Ltd.
Inhibition
6/8
7. Reflow Profile
8.0 Ordering Information
Part number
JM7130S22PL
V1 Dec-2017
Size (mm)
23 (L) x 21.5(W) x 4.2(H) mm
Remark
(+/-0.5mm)
Jess Technology Co., Ltd.
With 4Mbps data rate
7/8
Note:The module is limited to OEM installation ONLY;The OEM integrator is responsible
for ensuring that the end-user has no manual instructions to remove or install module.
If the FCC identification number is not visible when the module is installed inside another device,
then the outside of the device into which the module is installed must also display a label referring
to the enclosed module. This exterior label can use wording such as the following:
“Contains Transmitter Module FCC ID: XXXXXXXX”
when the module is installed inside another device, the user manual of this
device must contain below warning statements;
1、This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired
operation.
That separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and different antenna configurations.
This product is mounted inside of the end product only by professional installers OEM. They use this
module with changing the power and control signal setting by software of end product within the
scope of this application. End user can not change this setting.
The equipment complies with RF exposure limits. This module is limited to installation in mobile or
fixed applications. The antenna used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
V1 Dec-2017
Jess Technology Co., Ltd.
8/8

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.7
Linearized                      : No
Author                          : andy
Comments                        : 
Company                         : 
Create Date                     : 2018:01:03 12:08:16+04:00
Modify Date                     : 2018:07:19 12:01:50+08:00
Source Modified                 : D:20180103120816+04'08'
Subject                         : 
Trapped                         : false
Has XFA                         : No
XMP Toolkit                     : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03
Format                          : application/pdf
Creator                         : andy
Description                     : 
Title                           : 1
Creator Tool                    : WPS Office
Metadata Date                   : 2018:07:19 12:01:50+08:00
Keywords                        : 
Producer                        : 
Document ID                     : uuid:37ac0496-6a45-4c55-8d51-f34f7d642308
Instance ID                     : uuid:2e089a36-7bc4-46ec-9522-602ef14199a0
Page Count                      : 8

EXIF Metadata provided by EXIF.tools