BAO 8224 Remote Controlled Car User Manual Manual

BAO Ltd. Remote Controlled Car Manual

Manual

Download: BAO 8224 Remote Controlled Car User Manual Manual
Mirror Download [FCC.gov]BAO 8224 Remote Controlled Car User Manual Manual
Document ID347457
Application IDWNjobUQ/deFN+0WKUM11rw==
Document DescriptionManual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize21.04kB (263025 bits)
Date Submitted2003-08-12 00:00:00
Date Available2003-08-12 00:00:00
Creation Date2003-08-07 10:53:19
Document Lastmod2003-08-07 11:10:26
Document TitleManual
Document CreatorHP 9100C Digital Sender
Document Author: ITS ELECTRIC TOY

Ref
4 “Hangman“
Eiecf cur
Pork & Drive
Toys to enioy *~ A Antenna
Start & Eiect !
Ignition key
The door opens 8.
the cor Is eiecred 5
Electronic sounds
Drive and pafk with ligh'
your car !
P_a_____rk & Drive
Toys to engoy
__
Instructions
Batteries should be installed and changed by an adult.
Open the battery compartment with a coin/serew-driver
Make sure the batteries are installed in the correct polarity according
to the diagram. A wrong position can damage the toy, provoke lire or
the battery explosion
Close the lid oi the battery compartment.
Always change all the batteries. Do not m|x used and new batteries
Do not store baxeries with metal ob|ects : fire or explosion hazard.
Remove batteries when the toy ls not used for a long parlod oltlme.
Do not throw batteries in a tire
Do not attempt .o recharge batteries which are not rechargeable.
This my should not be used with rechargeable batteries.
Do not attempt a open batteries or rechargeable batteries.
In case a battery is swallowed consult immediately the doctor or a
poison center
It available get l'id ol your used batteries through a collection center
USE PHEFERABLV ALCALINE BATTERIES.
Never let button-ca" batteries ll! reach of young children.
Charging recha “geable batteries or accumulatorshould only be made
under the activri supervisron ol‘ an adult.
Do not use radio-control toys or any other toys on roads.
Only batteries ulthe same or equivalent type as recommended are
to be used.
Exhausted batteries are to be removed lrom the toy
The supplyterntinals are not be short-circoirad.
Dittarent types or batteries or new and used batteries are not to be mixed.
In case of mallunction, open the battery compartment, remove the
batteries, re-install them and close the battery compartment.
WARNING T0 PARENYS
Any battery chargerto be used wlth the my should be regularly
examined tor potential halards, such as damage to the cable or
cord, plug, enclosure or other parts, and, in the event at such
damage, the toy should not be used until the damaged has
been properly removed.
ru- Enwlxh
_———-———-———
For products such as RF remote controller
FCC ID: QWS 8224
This device complies with Part 15 at the FCC Rules, Operation is when to the
lollbwing two conditions: ll) this device may not cause narmtul interlerence,
and (2) this device mustaccept any interterence received, including
interteranco that may cause undesired operation.
Warning' Changes ormodilications to this unitnot expressly approved by the
party responsible for compliance could vord the user‘s authority to operate the
equipment.
NOTE: This equipment has been tested and tour-id to comply wlllt the limits lot
a Class E digital device, pursuant to Part 15 of the FCC Rules
These limits are designed to provide reasonable protection against harmlul
interference in a residential installation, This equrpnient generates, uses and
can radiate radio frequency energy and, it not installed and used in accordance
with the instructions, may cause harmlul inierterertce to radio communications,
However, there is no guarantee that tnterlerence erI not occur in a particular
installation. "this equipment does cause harmliil rnterterence to radio or
television reception, which can be determined by turning the equipment on and
on, the user is encouraged to try to currecttha interlerence by one or more or
the following measures
Reorient or-relocate the receiving antenna.
Increase the separation betweentha equipment and receiver.
[1 Connect the equipment into an outlet on a circuit difisrentlrum mat to
Whlch the receiver is needed
Consult the dealer or an experienced radio/W technician lor help.
Flu morn

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Creator                         : HP 9100C Digital Sender
Create Date                     : 2003:08:07 10:53:19
Author                          : ITS ELECTRIC TOY
Producer                        : 
Title                           : 
Subject                         : 
Modify Date                     : 2003:08:07 11:10:26+08:00
Page Count                      : 4
EXIF Metadata provided by EXIF.tools
FCC ID Filing: QWS8224

Navigation menu