BBPOS CHIPPERBT Chipper BT User Manual

BBPOS International Limited Chipper BT Users Manual

Users Manual

Warranty FCC Caution Statements:• Any damage or defects caused by a failure to follow the instruction which relate to this device or as the result of an accident, abuse, misuse, misapplication, product modication, improper voltage or current, acts of God, shipping damages or loss, or damage caused by service performed by anyone other than our company are expressly excluded from the warranty stated below. • We are not under any obligation to support the device for all operating environments, including but not limited to, interoperability with all current and/or future versions of software or hardware. • Please contact the dealer for any warranty or customer support services. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.- Consult the dealer or an experienced radio/TV technician for help.Caution: Any changes or modications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.©2016 BBPOS Limited. All rights reserved. BBPOS and Chipper™ are either trademark or registered trademarks of BBPOS Limited. iOS is the trademark of Apple Inc. Android™ is a trademark of Google Inc. Windows® is registered trademark of Microsoft Corporation in the United States and/or other countries. All details are subject to change without prior notice.Room 1602, 16/F, Tower 2, Nina Tower, No. 8 Yeung Uk Road, Tsuen Wan, Hong Kongwww.bbpos.comNeed Help?E: sales@bbpos.com | T: +852 3158 2585Revise v.2 / 20160704• Ensure to turn on the Bluetooth® function of your smartphone or tablet before use.• Please fully charge your Chipper™ BT before use. • Please ensure magstripe/EMV chip of the card is facing the right direction when swiping or inserting card.• Don’t drop, disassemble, tear, open, crush, bend, deform, puncture, shred, microwave, incinerate, paint, or insert foreign object into the device. Doing any of which will void the Warranty.• Don’t immerse the device into water and place near washbasins or any wet locations. Don’t spill any food or liquid on the device. Don’t attempt to dry the device with external heat sources, such as microwave or hair dryer. • Don’t use any corrosive solvent or water to clean the device. Recommend using dry cloth to clean the surface only. • Don’t use any sharp tools to point the internal components or connectors, doing which may lead to malfunction and void the Warranty.• Don’t try to disassemble the device to repair. Please contact your dealer for repair and maintenance.Cautions & Important Notes TroubleshootingProduct Specications Problems Recommendations• Please press the power on button to restart your device.• Please check if you can nd the device’s “Serial Number” (Shown on the back of device) in the “Scanned Device List” of your smartphone or tablet.• Please press the power on button to turn on the device again. The device will automatically connect with your smartphone or tablet again.• The device may be at lower battery level, please use the USB cable to recharge it, then retry.• Please ensure the device or smartphone/tablet is within the reception range.Device cannot be pairedDevice cannot read yourcard successfullyProblems Recommendations• Please press the power on button to turn on the device again. The device will automatically connect with your smartphone or tablet again.• The device may be at lower battery level, please use the USB cable to recharge it, then retry.• Please ensure the device or smartphone/tablet is within the reception range.• Please ensure the Bluetooth® function of your smartphone or tablet is turned on.• Please check the version of your operating system is supported for this device’s operation.Device lost the connection with your smartphone or tablet when the device is auto-o.• Please use a paper clip to press the reset button at the bottom for reboot.Device has no responseDevice does not work with your phone or tablet• Please check if the device has power when operating and ensure devices are connected.• Please check if the application instructs to swipe or insert card.• Please ensure there is no obstacle in the card slots.• Please check if the magstripe or chip of the card is facing the right direction when swiping or inserting card.• Please ensure your phone/tablet is supported model for this device’s operation.• Please swipe or insert card with a more constant speed.Device cannot read your card successfullyFunctions • EMV/PBOC Chip Card Reader (ISO 7816 Compliant Class A, B, C card) • Magnetic Stripe Card Reader Dual tracks (track 1 & 2 or track 2 & 3)Communication Interface Bluetooth® 4.0, USBPower & Battery Lithium polymer rechargeable battery 125mAH, 3.7VCharging Via micro USBSwipe Speed 15cm - 100cm/secLED Indicator Operating – green light ashing Low battery level – red light ashing Charging – red light ON Fully charged – green light ONSupport Operating System Android 2.1 or above, iOS 6.0 or above Windows Phone 8, MS Windows Product Size 61.8mm (W) x 44.5mm (H) x 14.2mm (D)Product Weight 29.8gOperating Temperature 0°C – 45°C (32°F – 113°F)Operating Humidity Max 95%Storage Temperature -20°C – 55°C (-4°F – 131°F)Storage Humidity Max 95%

Navigation menu