BIG KING HORN SPEAKER ENT YCWU7BT3 Transmitter User Manual BK235 T U7BT3 Introduction
BIG KING HORN SPEAKER ENT. CO., LTD. Transmitter BK235 T U7BT3 Introduction
Manual
BK235/T-U7BT3 Introduction
Valet Switch: This switch is used to prevent optional Automatic Last Door
Arming , Driver door Anti Hijack & Ignition Anti-Hijack of the system during
extended stopovers for service stations, maintenance, valet parking, washing,
etc..
The Red LED Status Light: Informs you of 7 different conditions the system can be
in and also serves as a visual deterrent to break-ins and theft.
Transmitter Operations and Features
Button I --
Pressing and releasing this button will arm the alarm.
Press Button 1 when system arm can activate the car finder function, the
parking will flash & siren will chirp for 10 times.
Button II --
Press and releasing this button will disarm the alarm.
(If this button is pressed within 3 seconds after arming the alarm, the door
protection zone and both auxiliary & built-in sensor will be bypassed.)
Button III –
Pressing and holding this button for 3 seconds when Ignition is off will
“Panic” the alarm - sounding the siren and flash the exterior lights for 30
seconds.
Press button# I Or II during panic will stop the panic.
Pressing and holding this button for 3 seconds when ignition is On will activate
the Remote Anti Hi Jack (AHJ) function.
If this button is pressed, and then the button I or II is pressed within 2 seconds,
the alarm will arm or disarm without siren confirmation chirps. (If this button is
pressed within 2 seconds after arming the alarm, the auxiliary & built-in sensor
will be bypassed.)
Button IV--
Pressing & hold this button for 3 seconds may be used to operate an additional
output for other optional devices such as remotely open the trunk.
Button III + IV
Pressing & hold both of these two buttons for 1 second can activate the 3rd
channel Output. The 3rd channel will become active as long as these two buttons
pressed. The maximum is 30 seconds.
Arming the Security System
Security System Armed and Activated
Disarming the Security System
Automatic Rearming:
The Valet Switch And Valet Mode
Valet Mode:
Remotely Lock/Unlock the door in valet mode:
Security Valet Override - Disarming The Security System Without The
Transmitter:
Exiting the Valet Mode:
The Red LED Status Light
The LED Status Light is used as a visual indicator of what
state the security system is in at any given time.
Security System Status: The primary function of the
Red LED Status Light is indicated the following normal operating parameters of the
security system:
Zone Violation
Optional Pre-Warning Shock Detection Circuit
Anti Hi Jacking appearance
Ignition Anti Hijack
Driver Door Anti-Hijack
Remote Anti Hijack
Suspend the AHJ mode
Disable the AHJ mode
Programming Transmitters
Ignition safety door lock & unlock
2 Stage safety disarm
PROGRAMMABLE FUNCTION
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference
received, including interference that may cause undesired operation.
Notice : The changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.