BIG KING HORN SPEAKER ENT YCWU7BT3 Transmitter User Manual BK235 T U7BT3 Introduction
BIG KING HORN SPEAKER ENT. CO., LTD. Transmitter BK235 T U7BT3 Introduction
Manual
BK235/T-U7BT3 Introduction Valet Switch: This switch is used to prevent optional Automatic Last Door Arming , Driver door Anti Hijack & Ignition Anti-Hijack of the system during extended stopovers for service stations, maintenance, valet parking, washing, etc.. The Red LED Status Light: Informs you of 7 different conditions the system can be in and also serves as a visual deterrent to break-ins and theft. Transmitter Operations and Features Button I -Pressing and releasing this button will arm the alarm. Press Button 1 when system arm can activate the car finder function, the parking will flash & siren will chirp for 10 times. Button II -Press and releasing this button will disarm the alarm. (If this button is pressed within 3 seconds after arming the alarm, the door protection zone and both auxiliary & built-in sensor will be bypassed.) Button III – Pressing and holding this button for 3 seconds when Ignition is off will “Panic” the alarm - sounding the siren and flash the exterior lights for 30 seconds. Press button# I Or II during panic will stop the panic. Pressing and holding this button for 3 seconds when ignition is On will activate the Remote Anti Hi Jack (AHJ) function. If this button is pressed, and then the button I or II is pressed within 2 seconds, the alarm will arm or disarm without siren confirmation chirps. (If this button is pressed within 2 seconds after arming the alarm, the auxiliary & built-in sensor will be bypassed.) Button IV-Pressing & hold this button for 3 seconds may be used to operate an additional output for other optional devices such as remotely open the trunk. Button III + IV Pressing & hold both of these two buttons for 1 second can activate the 3 rd channel Output. pressed. The 3 rd channel will become active as long as these two buttons The maximum is 30 seconds. Arming the Security System Security System Armed and Activated Disarming the Security System Automatic Rearming: The Valet Switch And Valet Mode Valet Mode: Remotely Lock/Unlock the door in valet mode: Security Valet Override - Disarming The Security System Without The Transmitter: Exiting the Valet Mode: The Red LED Status Light The LED Status Light is used as a visual indicator of what state the security system is in at any given time. Security System Status: The primary function of the Red LED Status Light is indicated the following normal operating parameters of the security system: Zone Violation Optional Pre-Warning Shock Detection Circuit Anti Hi Jacking appearance Ignition Anti Hijack Driver Door Anti-Hijack Remote Anti Hijack Suspend the AHJ mode Disable the AHJ mode Programming Transmitters Ignition safety door lock & unlock 2 Stage safety disarm PROGRAMMABLE FUNCTION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Notice : The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.2 Linearized : No Page Count : 3 Creator : BK235_T-U7BT3 Introduction.doc - Microsoft Word Create Date : 2007:06:28 16:40:10 Title : BK235_T-U7BT3 Introduction.doc Author : Administrator Producer : Acrobat PDFWriter 5.0Windows NT ª©EXIF Metadata provided by EXIF.tools