BNC Distribution 102917 Clevy Keyboard Bluetooth User Manual

BNC Distribution Clevy Keyboard Bluetooth

User manual

Clevy is a registered trademark of BNC Distribution Bluetooth Clevy Keyboard - User Manual Revision January - 2017 Batteries Two AA batteries are required to power the keyboard. Bluetooth pairing Go to the Bluetooth preferences of your computer and search for devices. Then briefly press the keyboard’s rear switch thanks to a pen or any other sharp object. The device “Clevy Bluetooth Keyboard US” should appear. Finally, you can activate it and start using it after following the steps suggested by your operating system. 1 2 3
Clevy is a registered trademark of BNC Distribution Led Lights There are two led lights on the Clevy Keyboard. One on the left (blue) and one on the right (red). The light on the left hand side indicates the Bluetooth connection status. The light on the right hand side indicates the modes. LED Keyboard Status LED Keyboard Status Continuous blinking BT pairing or discovery mode On Low power Blinks once every 5s BT paired and active Blink once Key become sticky Off Sleeping mode Blink twice Enter in iPad mode Blink three times Enter in Computer mode Note: In standby mode all LED’s are switched off. Key Repeat / Function Keys switch On the backside of the keyboard there is a switch. Here you can choose between two options: Key Repeat The repetition of a character when the user holds down a key representing that character. Function Keys Tool When you press and hold one of the following keys "F/ALT/AltGr/CTRL/SHIFT/Windows/Apple" for more than 2 seconds on the keyboard, the key is locked. You can then press another key to create a combination of keys. For example pressing ALT for 2 seconds, then pressing "F" for 2 seconds and finally press "4" will result in the "ALT+F4" command. Note: If a key is locked, type on it again to unlock it. Bluetooth connection status Mode
Clevy is a registered trademark of BNC Distribution Key Repeat Key Repeat ON / Function Key Tool OFF Function Keys Tool Key Repeat Key Repeat OFF / Function Key Tool ON Function Keys Tool iPad / Computer modes The default mode of the keyboard is "Computer mode" this mode works for every device including iPads. To toggle the mode press CTRL-ALT-I for "iPad mode" and CTRL-ALT-C for "Computer mode". When in iPad mode the user can access special features developed for iPad. Please note that a battery change will reset the mode to the default "Computer mode". iPad mode This mode features 2 shortcuts customized for iPad: - Home = ALT+CTRL+H - AltGr = LEFT+RIGHT Computer mode This mode is similar to typical keyboards. If you have any other questions, please have a look here: www.clevy.com/faq, or contact us at the following email address: info@bnc-distribution.com. iPad mode Computer mode CTRL+ALT+C CTRL+ALT+I
Clevy is a registered trademark of BNC Distribution Federal Communications Commission (FCC) Statement You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and2. This device must accept any interference received, including interference that may causeundesired operation of the device.FCC RF Radiation Exposure Statement: 1. This Transmitter must not be co-located or operating in conjunction with any other antenna ortransmitter.2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolledenvironment.

Navigation menu