Babaco Alarm Systems BBC-LBTX03 Remote Control User Manual new

Babaco Alarm Systems Remote Control new

User Manual

1USER MANUAL The remote has a battery in when you get the products and keep standby mode, when you push the button (refer the figure), the led will turn on and the remote transmitting signal to receiver. The transmitting will stop right now when you release the switch. If the Led is off when you push the button, please change a new battery as below: 1, release the screw on back 2, Open the plastic Cover 3, Take out the old battery, insert new battery 4, Covered and fill the screw 5, normal operation If the product faults, please contact with dealer.
2 FCC Warning: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules and IC Rules . These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. The equipment compliance with FCC radiation exposure limit set forth for uncontrolled Environment Changes or modifications to this unit not expressly approved by the party responsible for compliance will void the user’s authority to operate the equipment. Any change to the equipment will void FCC grant.

Navigation menu