Babaco Alarm Systems BBC-LBTX03 Remote Control User Manual new
Babaco Alarm Systems Remote Control new
User Manual
1
USER MANUAL
The remote has a battery in when you get the
products and keep standby mode, when you push
the button (refer the figure), the led will turn on and
the remote transmitting signal to receiver. The
transmitting will stop right now when you release the
switch.
If the Led is off when you push the button, please
change a new battery as below:
1, release the screw on back
2, Open the plastic Cover
3, Take out the old battery, insert new battery
4, Covered and fill the screw
5, normal operation
If the product faults, please contact with dealer.
2
FCC Warning:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules and IC
Rules . These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
The equipment compliance with FCC radiation exposure limit set forth for uncontrolled Environment
Changes or modifications to this unit not expressly approved by the party responsible for compliance will void the user’s authority to operate the
equipment. Any change to the equipment will void FCC grant.