Baicells Technologies U4GAP1000 LTE-FDD Base Station User Manual Neutrino 224 LTE Indoor Small Cell Specification

Baicells Technologies Co., Ltd. LTE-FDD Base Station Neutrino 224 LTE Indoor Small Cell Specification

Users Manual

Spectra Outdoor LTE-FDD Base Station Specification
1 Introduction The Baicells Spectra is outdoor LTE-FDD base station that works on unlicensed band of 5.8GHz. Since it works in standalone mode, it doesn’t require any licensed band to build a network. With 2*320mw output power (2x2 MIMO with 320mw output each channel) and embedded antenna, Spectra is compact, light, ultimately easy to install and maintain, and has excellent performance. It can be used to build a network completely based on unlicensed band or as additional capacity for network based on licensed bands, which can help operators to extend and improve their business, without the huge cost of buying license. With the advantage of LTE technology, Spectra enjoys much higher receiving sensitivity and better QoS control, if compared to WiFi based technology. And also Spectra support continuous networking thanks to LTE technology with GPS synchronization. With high capacity and easy deployment, the LTE-U eNB can help mobile operators to provide better coverage and higher capacity with minimal effort. The typical topology of LTE-U deployment is as follows.
2 Highlights Easy Deployment  Super slim and beautiful design, suitable for private and public deployments.  Any IP based backhaul can be used, including public transmission.  Support GPS synchronization.  Low power consumption, can be integrated with solar power conveniently.  Plug-and-Play with SON capabilities.  Internal high gain directional antenna and GPS antenna. Better Performance  Peak rate 150Mbps@ Downlink, 50Mbps@Uplink with 20MHz spectrum.  Maximum 32 concurrent users.  Support eGW (optional) for S1 aggregation to reduce signaling load of MME.  Support local traffic offload and charging in cooperation with eGW.  Support 10MHz/20MHz operation bandwidth Easy Management
3  Efficient remote configuring, monitoring, and maintaining operations with Baicells network management system (NMS) BaiOMC.  Highly secured with equipment certification against potential intrusion risk. Smooth Evolution  Abundant features achievable with software upgrade.  Smooth evolution to C-RAN architecture, which support centralized scheduling for better networking performance, with Baicells’ central network unit (CNU). Hardware Specifications Item Description LTE Mode FDD Frequency Bands DL:5725-5825MHz UL:5150-5250MHz Channel Bandwidth 10MHz, 20 MHz MAX Output Power 25 dBm /Ant Receive Sensitivity -102 dBm/Ant Synchronization GPS Backhaul 1 Optical (SFP) and 1 RJ-45 Ethernet interface (1 GE) MIMO DL: 2 x 2 Dimensions 120mm (L) x 93mm (W) x 37.5mm (H) Installation Type Pole, wall Antenna 14dBi, internal directional antenna Horizontal beam width 45°, vertical beam width 12° Polarization mode: ±45° Power Consumption < 65W
4 Power Supply 48V DC 1.5A (maximum) PoE+ power supply Weight Less than 4.0kg Software Specifications Item Description LTE Standard 3GPP Release 9 Peak Rate 20MHz: DL: 150Mbps, UL: 50Mbps User Capacity 32 concurrent users QoS Control 3GPP standard QCI Modulation UL: QPSK, 16QAM DL: QPSK, 16QAM, 64QAM Traffic Offload LIPA (Local IP Access) SIPTO (Selected IP Traffic Offload) SON Automatic setup ANR (Automatic Neighbor Relation) PCI confliction detection Spectrum Scanning Supported UL Interference Detection Supported RAN Sharing Supported Network Management Interface TR069 MTBF ≥ 150000 hours MTTR ≤ 1 hour Maintenance Remote/local maintenance Online status management
5 Performance statistics Fault management Local or remote software upgrade Logging Connectivity diagnosis Automatic start and configuration Alarm reporting KPI Recording User information tracing Signaling trace Environmental Specifications Item Description Operating Temperature -40°C to 55°C Storage Temperature -45°C to 70°C Humidity 5% to 95% Atmospheric Pressure 70 kPa to 106 kPa Ingress Protection Rating IP65 Power interface Lightning Protection Differential mode: ±10 KA Common mode: ±20 KA
6 Model List Filter Range Models Description UL/DL: 5150MHz~5825 MHz u4G-AP1000 u4G-AP1000(FDD Outdoor Micro cell, Unlicensed frequency, DL:5725-5825MHz/UL:5150-5250MHz, 2T2R, 25dBm,48V DC, PoE+, America standards ) Regulatory Compliance FCC Compliance This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. Warning This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 60 cm between the radiator & your body. ISEDC Compliance This device complies with Innovation, Science, and Economic Development Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
7 Le présent appareil est conforme aux CNR d' Innovation, Science et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 60 cm from all persons and must not be collocated or operating in conjunction with any other antenna or transmitter, End-Users must be provided with transmitter operation conditions for satisfying RF exposure compliance.

Navigation menu