Bang and Olufsen a s BEOCOM2 Cordless Telephone Handset User Manual GS1 BeoCom 2 US indd

Bang & Olufsen a/s Cordless Telephone Handset GS1 BeoCom 2 US indd

GS1 BeoCom 2 US side 21 Manual

2021>> For your information… For the American market only… This equipment complies with Part 68 of the Federal Communications Commission (FCC) rules for the United States. A label is located on the underside of the base unit containing either the FCC registration number and Ringer Equivalence Number (REN). You must upon request, provide the following information to your local telephone company: USOC Jack Type: RJ11 REN: 0.1BShould you experience trouble with this telephone equipment, please contact: Bang & Olufsen America, Inc. 780 West Dundee Road Arlington Heights IL 60004 U.S.A. Phone: (847) 590-4900 Main Fax: (847) 255-7805 The REN is used to determine the quantity of devices which may be connected to the telephone line. Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as deter-mined by the total RENs, contact the local telephone company. If trouble is experienced with BeoCom 2, for repair or warranty information, please contact: Bang & Olufsen America, Inc. 780 West Dundee Road Arlington Heights IL 60004 U.S.A. Phone: (847) 590-4900 Main Fax: (847) 255-7805 If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved. This equipment cannot be used on public coin phone service provided by the telephone company. Connection to party line service is subject to state tariffs. Your telephone company may discontinue your service if your equipment causes harm to the tele-phone network. They will notify you in advance of disconnection, if possible. During notification, you will be informed of your right to file a complaint to the FCC. Occasionally, your telephone company may make changes in its facilities, equipment, operation, or procedures that could affect the operation of your equipment. If so, you will be given advance notice of the change to give you an opportunity to maintain uninterrupted service. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This device complies with FCC SAR limit of 1.6mW/g. The maximum SAR value measured was 0.26mW/g. This device must not be co-located or operating in con-junction with any other antenna or transmitter.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harm-ful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception, which can be deter-mined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:– Reorient or relocate the receiving antenna.– Increase the separation between the equipment and receiver.– Connect the equipment into an outlet on a circuit different from that to which the receiver is con-nected.– Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause un-desired operation.

Navigation menu