Bang and Olufsen a s BEOCOM2 Cordless Telephone Handset User Manual GS1 BeoCom 2 US indd

Download:
Mirror Download [FCC.gov]
Document ID	384360
Application ID	NlxLV1M6+bIqBgUSx/zLdQ==
Document Description	GS1 BeoCom 2 US side 21 Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	2.73kB (34118 bits)
Date Submitted	2003-12-23 00:00:00
Date Available	2003-12-23 00:00:00
Creation Date	2003-12-19 10:33:06
Producing Software	Adobe PDF Library 5.0
Document Lastmod	2003-12-19 12:31:12
Document Title	GS1 BeoCom 2 US.indd
Document Creator	Adobe InDesign 2.0

20
21
>> For your information…
For the American market only…
This equipment complies with Part 68 of the Federal
Communications Commission (FCC) rules for the
United States.
A label is located on the underside of the base unit
containing either the FCC registration number and
Ringer Equivalence Number (REN). You must upon
request, provide the following information to your
local telephone company:
USOC Jack Type: RJ11
REN: 0.1B
Should you experience trouble with this telephone
equipment, please contact:
Bang & Olufsen America, Inc.
780 West Dundee Road
Arlington Heights
IL 60004 U.S.A.
Phone:
(847) 590-4900
Main Fax: (847) 255-7805
The REN is used to determine the quantity of devices
which may be connected to the telephone line.
Excessive RENs on the telephone line may result in the
devices not ringing in response to an incoming call. In
most, but not all areas, the sum of RENs should not
exceed five (5.0). To be certain of the number of
devices that may be connected to a line, as determined by the total RENs, contact the local telephone
company.
If trouble is experienced with BeoCom 2, for repair or
warranty information, please contact:
Bang & Olufsen America, Inc.
780 West Dundee Road
Arlington Heights
IL 60004 U.S.A.
Phone:
(847) 590-4900
Main Fax: (847) 255-7805
If the equipment is causing harm to the telephone
network, the telephone company may request that
you disconnect the equipment until the problem is
resolved.
This equipment cannot be used on public coin
phone service provided by the telephone company.
Connection to party line service is subject to state
tariffs.
Your telephone company may discontinue your
service if your equipment causes harm to the telephone network. They will notify you in advance of
disconnection, if possible. During notification, you
will be informed of your right to file a complaint to
the FCC.
Occasionally, your telephone company may make
changes in its facilities, equipment, operation, or
procedures that could affect the operation of your
equipment. If so, you will be given advance notice of
the change to give you an opportunity to maintain
uninterrupted service.
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
device complies with FCC SAR limit of 1.6mW/g. The
maximum SAR value measured was 0.26mW/g. This
device must not be co-located or operating in conjunction with any other antenna or transmitter.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation.
If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by
one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause undesired operation.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Modify Date                     : 2003:12:19 12:31:12+01:00
Create Date                     : 2003:12:19 10:33:06Z
Producer                        : Adobe PDF Library 5.0
Creator                         : Adobe InDesign 2.0
Trapped                         : False
Page Count                      : 1
Creation Date                   : 2003:12:19 10:33:06Z
Mod Date                        : 2003:12:19 12:31:12+01:00
Metadata Date                   : 2003:12:19 12:31:12+01:00
Document ID                     : adobe:docid:indd:b2fd91d2-3204-11d8-ae8b-eb460e58b846
Version ID                      : 1
Rendition Class                 : proof:pdf
Rendition Of Document ID        : adobe:docid:indd:b2fd91d2-3204-11d8-ae8b-eb460e58b846
Rendition Of Version ID         : 1
Rendition Of Rendition Class    : default
Format                          : application/pdf
Title                           : GS1 BeoCom 2 US.indd
Tagged PDF                      : Yes

EXIF Metadata provided by EXIF.tools