Belco Co PM5820 5.8GHz/2.4GHz 40 Channel Cordless Phone (Base) User Manual FCC Information
Belco International Co Ltd 5.8GHz/2.4GHz 40 Channel Cordless Phone (Base) FCC Information
Belco Co >
Contents
- 1. User Manual
- 2. FCC Information
FCC Information
PM5820Manual_En-ˆ •´ 2004.10.6 12:59 PM ˘ ` 9 AGFA SelectSet Avantra 25 WARRANTY FCC REGULATIONS WARNING:Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. IMPORTANT! SALES SLIP OR EVIDENCE OF PURCHASE DATE REQUIRED. This limited warranty gives you specific legal rights: you may also have other rights, which vary from state to state. The limited warranty is extended only to the original consumer of a PhoneMate branded product by the Manufacturer and is valid only with respect to consumers within the United States of America and Canada. Should this product prove defective by reason of improper workmanship or material during the period of one (1) year from date of original purchase, the Manufacturer will repair or, at its option, replace the product without charge for parts or labor. If Manufacturer elects to replace the product, such replacement may be accomplished with a factoryreconditioned unit. This limited warranty does not apply: (a) to any product damaged by accident, misuse, improper line voltage, lightning, fire, water, or other acts of nature, (b) if the product is altered or repaired by anyone other than the Manufacturer or one of its authorized warranty stations or (c) if the FCC-approved connector plugs are removed. This limited warranty does not cover broken or marred cabinets. Except to the extent prohibited by law, all implied warranties made by the Manufacturer in connection with this product are limited in duration to a period of one (1) year from the date of original purchase, and no warranties, whether expressed or implied, shall apply to this product after said period. Should this product prove defective in workmanship or material, the consumer’s sole remedies shall be such repair or replacement as is herein above provided. Under no circumstances shall the Manufacturer or PhoneMate Corporation be liable for any loss or damage, direct, consequential, or incidental arising out of the use of or inability to use this product. Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. In order to obtain warranty service, you must provide evidence of purchase date. For your convenience, keep the dealer’s dated bill of sales or delivery ticket as evidence of the purchase date. PhoneMate and the PhoneMate Logo are registered trademarks of PhoneMate Corporation and are used under license from PhoneMate Corporation. Model PM5820 1. This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the bottom of this equipment is a label that contains, among other information, a product identifier in the format US : AAAEQ##TXXXX. If requested, this number must be provided to the telephone company. 2. The USOC number of the registration jack for the equipment is RJ11C. 3. A FCC compliant telephone cord and modular plug is provided with this equipment. This equipment is designed to be connected to the telephone network or premises wiring using a compatible modular jack which is Part 68 compliant. See Installation Instructions for details. 4. The REN is used to determine the quantity of devices which may be connected to the telephone line. Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the local telephone company. 5. If this terminal equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. But if advance notice isn’t practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is unnecessary. 6. The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operation of the equipment. If this happens the telephone company will provide advance notice in order for you to make necessary modifications to maintain uninterrupted services. 7. The equipment cannot be used on public coin phone service provided by the telephone company. Connection to party line service is subject to state tariffs. 8. Please follow all instructions when replacing any parts (e.g. battery replacement section), otherwise do not attempt to alternate or repair any parts of the device except those specified. 9. This equipment, if it uses a telephone handset is hearing aid compatible. 10. If trouble is experienced with this equipment, for repair or warranty information, please contact the service center below. If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved. 38 PM5820Manual_En-ˆ •´ 2004.10.6 12:59 PM ` 11 AGFA SelectSet Avantra 25 FCC R EG ULAT IONS G LOSSA R Y Service can be obtained at: P B X ( P r ivat e B r anch Ex change) Ð A small, central, privately owned, switching telephone system where a digit (like "9") must be dialed first in order to access an outside line PhoneM ate Service C enter 14515 Valley View Ave. #B Santa Fe Springs, C A 90670 TEL : 1-562-407-0227 INT ER FER ENCE INFOR M A T ION: P A R T 1 5 OF FCC R ULES Some telephone equipment generates and uses radio frequency energy, which if not properly installed, may cause interference to radio and television reception. This unit has been tested and found to comply with the limits for a Class B computing device in accordance with the specifications in Part 15 of the FCC rules. These specifications are designed to provide reasonable protection against such interference in a residential installation. If this equipment does cause interference to radio or television reception, when itÕs in use, the user is encourage to try to correct the interference by one or more of the following measures: A. Where it can be done safely, reorient the radio or TV receiving antenna. B. To the extent possible, relocate the television, radio, or other receiver with respect to the telephone equipment. C. If your telephone products run on AC power, plug your product into an AC outlet thatÕs not on the same circuit as the one used by the radio or television. NOT ICE : If your home has a wired alarm equipment system connected to the telephone line, ensure the installation of this PM 5820 does not disable your alarm equipment. If you have questions about what will disable the alarm equipment, consult your telephone company or a qualified installer. This device complies with Part15 of the FCC rules. Operation is subject to the following two conditions : (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Privacy of communications may not be ensured when using this phone. M odel PM 5820 FLA SH Ð A signal sent by the phone to the local telephone company supporting services such as call waiting. R EDIA L Ð Performs single button dialing of the last number dialed R INGER LEV EL CONT R OL Ð Permits adjustment of the ringer volume level. SP EED DIA LING Ð Allows programming of frequently dialed numbers so that they can be dialed with the two touch speed dial button T ONE/ P ULSE OP T ION Ð Enables you to switch from pulse (rotary dial method) to tone (push button) dialing. V OLUM E LEV EL CONT R OL Ð Permits volume adjustment of the handset and headset during a conversation. LCD Ð Liquid Cr yst al Display Ð This is the display on the handset used to display the Caller ID information as well as in programming the PM 5820 FSK Ð Fr equency Shif t K ey Ð A type of signalling service used for Voice M ail and other services offered by some local telephone companies. V oice M all Ð A service offered my some local telephone companies where callers can leave a voice message when no one answers the phone call. Caller ID Ð The information received by your PM 5820 from the telephone company about the person who is calling you. Depending on your local telephone company this can be the phone number of the person who called you and/or the name of the individual that the phone number is registered to. Call W ait ing Ð A service offered by some local telephone companies, whereby an audible notification is sent to you while you are currently on the phone, indicating that someone else is attempting to call you. Call W ait ing Caller ID Ð A service offered by some local telephone companies, whereby an audible notification along with the number and name (if available) is sent to you while you are currently on the phone, indicating that someone else is attempting to call you providing you with the information on who that individual is Cont r ast Ð The brightness of the display 37
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Modify Date : 2004:10:26 10:49:55+08:00 Create Date : 2004:10:26 10:49:35+08:00 Producer : Acrobat Distiller 4.0 for Macintosh Creator Version : 9 Container Version : 9 Creator : Adobe Illustrator(R) 9.0 For : kwak kyungsook, Belco Title : D:\PM5820\Manual\Rev\ \PM5820Manual_En-.pdf Bounding Box : 0 -1 806 590 Page Count : 2 Mod Date : 2004:10:26 10:49:55+08:00 Creation Date : 2004:10:26 10:49:35+08:00 Metadata Date : 2004:10:26 10:49:55+08:00 Has XFA : NoEXIF Metadata provided by EXIF.tools