Belkin Components F5U010 7 Port USB Hub User Manual Updated Manual

Belkin Components 7 Port USB Hub Updated Manual

Updated Manual

Page 1 - 27 Port USB Hub User’s ManualIntroductionThis product confirms to USB Specification Rev. 1.1 and HID class definitionRev.1.0.The HUB topology supports up to 127 physical devices in a tired-starconfiguration.Features! Confirms to USB Specification Revision 1.1 and HID Class Definition Rev.1.0.! Plug and play compatible.! A maximum of 127 devices can be supported.! A maximum 5 meter connection cable can be used between two hubs.! Powered by self-powered or Bus powered.! All downstream ports are supported with over current protection.! Both low speed and high speed devices are supported.! LED displays indicate power on and connection to each port.System Requirement! IBM PC Compatible! Supports Windows 95 OSR 2.1, 98, 98 SE and 2000 ProfessionalInstallation! When connecting this unit for the first time a message box will display :“Searching for unknown hardware device, searching software for installation”! Your computer will then start up the Device Driver Wizard, and will install theunit. This product is recognized as “generic USB Hub”! Once your computer has confirmed installation, you can then connect any USBdevices you wish to the Hub.Packing List! USB HUB! Power! USB Cable (1.8m , Connector Type-A to Connector Type-B)! This manualSpecification
Page 2 - 2Standard USB Spec Rev.1.1 and HID class definition Rev 1.0Topology Star typeTransmission speed 12MbpsTransmission media USB cableInterface Up stream port (type B): 1 portDown stream port (type A): 7 portsPower Self-powered or Bus-poweredOperating Environment 0 C to 40 COperating humidity 5%~90% RH (non-condensing)Storage temp -5C to 70 CDimension 165 x 90 x 28 mmWeight 970 gNotice:For a Class B digital device or peripheral. The instructions furnished the user shallinclude the following or similar statement, placed in a prominent location in the textof the manual: Note; This equipment has bean tested and found to comply with the limits for aClass B digital device, pursuant to part 16 of the FCC Rules, These limits aredesigned to provide reasonable protection against harmful interference in a residentialinstallation. This equipment generates, uses and can radiate radio frequency energyand, if not installed and used in accordance with the instructions, may cause harmfulinterference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does causeharmful interference to radio or television reception, which can be determined byturning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures:Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit different from that to whichthe receiver is connected.Consult the dealer or an experienced radio/TV technician for help.

Navigation menu