Bontec BONTEC-T011 Transmitter Keyless User Manual Remote Keyless Entry BONTEC T011

Download:
Mirror Download [FCC.gov]
Document ID	254871
Application ID	w2WFfgv2veJRVRe5VXrRPg==
Document Description	users manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	14.36kB (179471 bits)
Date Submitted	2002-07-08 00:00:00
Date Available	2002-07-02 00:00:00
Creation Date	2002-06-25 13:15:34
Producing Software	Acrobat Distiller 4.05 for Windows
Document Lastmod	2002-06-25 13:15:48
Document Title	Remote Keyless Entry(BONTEC-T011)
Document Creator	Microsoft Word 9.0

Remote Keyless Entry
(BONTEC-T011)
BONTEC Co., Ltd.
#27-31, HANCHUN-RI, DUCK-SAN -MYUN,, JINCHUN-GUN,CHUNG-BUK,KOREA
- INDEX -
- An outline
- Description of Transmitter and Receiver
FCC NOTICE
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC FULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITION:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDERSIRED
OPERATION.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communication. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures :
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit difference from that to which
the receiver is connected.
- Consult the dealer of an experienced radio/TV technician for help.
NOTE : The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s
authority to operate the equipment.
An outline of Transmitter and ETACS
1. How to use BONTECBONTEC-T011,R011
- BONTEC-T011,R011 is Remote Keyless System.
- This unit control door lock/unlock with wireless.
- Lock button push , then door lock.
- Unlock button push, then door unlock.
- Trunk button push, then Trunk Open
- Panic button push, then Panic Alarm
2. Introduction of Transmitter
- Transmitter has three button
- Button marking are LOCK, UNLOCK, TRUNK, PANIC
- Transmitter use thee voltage battery
- Frequency is 315Mhz
- Modulation item is SAW Resonator
- Transmitter use Rolling code algorithm
3. Introduction of Receiver
- Receiver control car door
- Receiver has RF module(315)
- RF module use superregentive circuit
- Receiver send Door Lock/Unlock/Trunk open/Panic to ETACS
- Receiver has internal eeprom that save code
Description of Transmitter and ETACS
1. PRIMARY FUNTION
- Remote door lock/unlock
- Remote Back Glass Open/panic
- LED turn on ( When button is pushed )
- Operating distance : 7~ 10 m
- Id input(setting mode)
2. ELECTRICAL CHARACTERISTICS
TRANSMITTER
RECEIVER
Operating voltage
3 VDC
10 ~ 16 VDC
Consumption current
Max 20mA
Max 5mA
Operating frequency
3.
315㎒
Power
10mW under
Sensitivity
-100dBm(typical)
Operating temperature
-20 ~ +60℃
-30 ~ +80℃
etc
AM modulation
Superheterodyne
DESCRIPTION MODE
1) Mode
Mode
ID INPUT
(Setting Mode)
Normal Mode
B+
ON
ON
CAR KEY
OFF
SETTING
ON
OFF
2) Id input(Setting Mode)
When Setting Mode,
lock button push,
4. OPERATING DIAGRAM
1) TRANSMITTER
5. OPERATING DIAGRAM
BATTERY
LOCK/UNLOCK
DOOR CONTROLLER
START SETTING /
END SETTING
IG SWITCH
LOCK
KEYLESS SWITCH
UNLOCK
START
SETTING
SET SWITCH
END
SETTING
* DESCRIPTION OF OUTPUT SIGNAL
<- START ->
<- T3 ->
T1 : 24 msec
T2 : 8 msec
T3 : 49 msec
<- " 0 " ->
T2
<-T1->
<- " 1 " ->
<-T1-> T2
* A cause
BATTERY
IG SW.
SET SW.
KEYLESS SW.
OPERATING MODE
SETTING MODE
OFF
OFF
OFF
ENABLE
DISABLE
OFF
OFF
ON
DISABLE
DISABLE
OFF
ON
OFF
DISABLE
DISABLE
OFF
ON
ON
DISABLE
DISABLE
ON
OFF
OFF
DISABLE
DISABLE
ON
OFF
ON
DISABLE
DISABLE
ON
ON
OFF
DISABLE
DISABLE
ON
ON
ON
DISABLE
ENABLE
433.92MHz
LOCK
UNLOCK
TRANSMITTER
ANTENNA
LOCK
UNLOCK
LOCK / UNLOCK Signal
END SETTING
RECEIVER
R.K.E(Remote keyless entry)
START SETTING
DOOR CONTROLLER
DOOR

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Producer                        : Acrobat Distiller 4.05 for Windows
Creator                         : Microsoft Word 9.0
Modify Date                     : 2002:06:25 13:15:48+09:00
Author                          : °­¿µÈñ
Title                           : Remote Keyless Entry(BONTEC-T011)
Create Date                     : 2002:06:25 13:15:34
Page Count                      : 8
Page Mode                       : UseNone

EXIF Metadata provided by EXIF.tools