Bosch Security Systems ZIGB01 Wireless TriTech Motion Detector for the ISW-ZDL1-WP11G and Wireless PIR Motion detector for the ISW-ZPR1-WP13 User Manual F01U284862 01a ISW ZDL1 WP11G Inguide indd
Bosch Security Systems, Inc. Wireless TriTech Motion Detector for the ISW-ZDL1-WP11G and Wireless PIR Motion detector for the ISW-ZPR1-WP13 F01U284862 01a ISW ZDL1 WP11G Inguide indd
User Manual
6x 1.5 V Duracell MN1500 AA Alkaline Panasonic AM-3PIX AA Alkaline 131 mm (5.2 in) TriTech motion detector ISW-ZDL1-WP11G 0°C to +49°C Pet friendly Animaux acceptés 51 mm (2.0 in) 1 ≤ 45 kg (100 lbs) 2 ≤ 27 kg (60 lbs) 67 mm (2.6 in) (+32°F to +120°F) 2.2 - 2.7 m (7.5 - 9 ft) 0 - 93% Non-Condensing humidity ≤ 10 en Installation and Operation Guide AA AA AA AA 2 sec AA AA Optional mounting brackets / Support de montage en option: B328, B335, B338 10 2 sec 15 sec Refer to the instruction manual that came with the control panel to complete the pairing process. Reportez-vous aux instructions fournies avec le panneau de commande pour terminer le processus d’appariement <3 min 5 sec 11 90 sec Green Vert Yellow Jaune Red Rouge © 2013 Bosch Security Systems, Inc. 12 13 80 sec 14 10 sec 15 12 12 13 F.01U.284.862 | 01a | 2013.06 | 1 1 <3 min Normal Operation Fonctionnement Normal FCC This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. AA AA AA AA AA AA Reset Réinitialiser AA AA AA AA <4 sec AA IC This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. AA AA AA AA AA This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help AA AA Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. AA AA AA Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. AA AA AA AA AA AA AA AA Low Battery / Trouble Condition Batterie faible / Condition de trouble AA © 2013 Bosch Security Systems, Inc. 130 Perinton Parkway Fairport, NY 14450 Conformément à la réglementation d’Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d’un type et d’un gain maximal (ou inférieur) approuvé pour l’émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l’intention des autres utilisateurs, il faut choisir le type d’antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l’intensité nécessaire à l’établissement d’une communication satisfaisante. Copyright This document is the intellectual property of Bosch Security Systems, Inc. and is protected by copyright. All rights reserved. Trademarks All hardware and software product names used in this document are likely to be registered trademarks and must be treated accordingly. Bosch Security Systems, Inc. product manufacturing dates Use the serial number located on the product label and refer to the Bosch Security Systems, Inc website at: http://www.boschsecurity.com/datecodes/. F.01U.284.862 | 01a | 2013.06 | 2
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : Yes Author : rum1fp Create Date : 2013:09:12 13:51:12-04:00 Modify Date : 2013:09:12 13:51:12-04:00 XMP Toolkit : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26 Creator Tool : PScript5.dll Version 5.2.2 Producer : Acrobat Distiller 10.1.3 (Windows) Format : application/pdf Title : F01U284862-01a_ISW-ZDL1-WP11G_Inguide.indd Creator : rum1fp Document ID : uuid:d705918b-8045-4abe-b98c-82226ff93090 Instance ID : uuid:c3bb86a6-a77f-4bf5-b351-af78b56ae447 Page Count : 2EXIF Metadata provided by EXIF.tools