Breo Technology IDREAM3 HEAD MASSAGER User Manual

Shenzhen Breo Technology Co.,Ltd HEAD MASSAGER

User Manual

User Manual Main Unit and Remote Control1 Main Unit, 1 Controller, 1 Power Charger, 3 Batteries, 1 User Manual, 1 Set of Earphones, 1 USB CableThank you for purchasing Breo iDream3.Please read this manual carefully before using the product, and keep it in a safe place for future reference. For relief of minor aches and painsiDream3 adopts air pressure, vibration, and hot compress massaging technology to massage the head and ocular regions. It comes with a wireless remote control and built-in MP3 player. You can now enjoy wonderful music while massaging, further relaxing your head and eyes.3Power on Open the battery cover on the back of the remote control.Place 3 AAA batteries in accordance with the positive and negative poles.Close the battery cover. (Picture1)1.2.3.Music DownloadingConnect the main unit to computer using the supplied USB cable;Push the power protection key on the main unit to Level “I”;Copy MP3 music to the device. 1.2.3.Wear Use the back dial to adjust the distance between head to establish the most comfortable fit, and wear main unit.Use the top dial in setting the distance above head.1.2.(picture 1)to Level “I”(picture 2)11. 10. 2. 1. 3. 7. 4. 8. 6. 5. 9. Please make sure that one main unit is corresponding to one remote controller. The operation of encoding joint with multiply remote controller to the main unit is prohibited.EYE & HEAD MASSAGERIntroductionInside the packageMain Unit ControllerFunction DeploymentLCD ScreenON/Off Operating Buttons Air dischargeDC power interfaceEarphone Jack Power Switch Protection key Encoding Key USB PortSize Adjusting KnobTightness Adjusting Knob1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. Pressure Reduction Valve DC Power PortLCD Screen：From top to bottom: Time /Air Pressure/Vibration/Hot Compress/MusicOperating Button:Clockwise: Up Button/Function Mode Next/Down Button /Function Mode Previous Center: OK ButtonPower switch protection key: Push left or right to turn ON/OFFMUST push power switch to Level “O” after each use Important: Make sure that only one device is paired with the remote control. Multiple pairing of remote control and main unit is strictly prohibited.Attention:In case of problem with connection between the main unit and remote control, you can perform joint encoding operation:Turn the remote control off, and push the power switch of the mainunit to level “O”;Press and hold [8] encoding key of the main unit. While still holding it, push the power switch of the main unit to level “I” to turn it on; The blue LED indicator on the front of the main unit flashes.1.2.3.and lights up while the main unit’s blue LED indicator turns off-it meansthe encoding is successful (This step should be completed within 6 Release [8] encoding key, and simultaneously press thekeys of the remote control for 2-3 seconds. The remote control LCDseconds). If unsuccessful, repeat from the start.Push the power switch of the main unit to level “O”, then back tolevel “I”. Both the main unit and remote control should now be working.Prior to use, check the integrity of the machine and accessories:No damage on power chargerBattery power is sufficient1.2.PreparationAttention:Push the power switch on the main unit to Level “O”. Keep the massager turned OFF while charging. Charging time is approximately 3-4 hours.If the massager is turned on while recharging, all functions of the product will run normally. The machine will automatically stop charging to prevent damage to the device.If the power of the battery is lower than 3.2 0.1V, the machine will automatically turn off. If the LED indicator of the main unit flashes, it means the lithium battery is low. Recharge the main unit.1.2.3.+Manually operate related buttons to select air pressure mode, vibration mode, hot compress temperature, change music and/or massage duration.10.11.12.13.14.15.16.1 7.To clean, wipe with aseptic cotton and alcohol. Do not wash orimmerse in water.This product is not a substitute for healthcare professionals' adviceand treatment. In case of doubt or if necessary, please consult yourhealthcare professional.Please use ONLY the DC4.5V power charger that comes with thepackage, and handle it with care.It is very IMPORTANT to turn the power of the main unit OFF aftereach use and before storage to avoid damage to the machine.Problem Possible Reason Possible SolutionPower-On FailureWeak air pressureor vibrationLithium battery of the main unit is lowLithium battery of the main unit is lowRecharge the main unit at onceRemote control batteries are low/ outChange batteriesRemote control batteries are not installed correctlyCheck if positive/negative poles of batteries are positioned rightMake sure the batteries are snug in placeRecharge the main unit at oncePower Switch Protection key is not turned onPush this key to Level “I”Ideal Environment：Temperature 5℃～40℃ Relative Humidity ≤80%Main Unit：L282mm X W206mm X H254mmController ：L132mm X W44mm X H24mmNet Weight：DC/Power：Atmospheric Pressure: 860hpa～1060hpa 1125gDimension： DC: 4.5V Power: 4.5WWhen operational problems occur, please refer to the chart below.Do not disassemble the machine or try to repair it by yourself.TroubleshootingSpecifications2.3.StorageIf left unused, checking the product/turning the power on every 6 months is recommended.Do not store near the floor, wall or roof.Maintain good ventilation and keep away from direct sunlight and corrosive gases.Made in ChinaManufactured by: Shenzhen Breo Technology, Co., Ltd.Company Address: Jinshan Bldg., No. 5033, Shennan East Road, Shenzhen, 518008, China 1.Precautions1.2.3.Please read the manual carefully and operate accordingly.Children under 7 years old cannot use the massager.This massager should not be used by:a. People who suffer from brain disease or have undergone brain surgeryb. People who are suffering from glaucoma, retinoschisis or other serious eye diseasesc. People who have physical or mental disorderAttention:When you feel the air pressure is too much and/or uncomfortable, press the Pressure Reduction Valve on the main unit to release air.If the massager will not be used for a long time, remove the batteries toavoid battery leakage.9.Time — Press Button to select “Time”— Press Button to select massage duration 15 minutes/10 minutes/5 minutesPress Button to choose — Press Button to turn on/off a function— Press Button to select air pressure mode, vibration mode, hot compress temperature, change music and/or massage durationamong functions(Time, Air Pressure, Vibration, Heat, and Music)Vibration — Press Button to select “Vibration”,then Press Button— Press Button to select from the 5 different modes of vibration—Off/On: Press Button to turn off/on VibrationHeat compression— Press Button to select “Heat Compression”— Press Button to select low temperature or high temperature— Off/On: Press Button to turn off/on Heat CompressionAir pressure — Press Button to select “ Air Pressure”— Press Button to select from the 5 different modes of air pressure (Preset Default: Mode 5 – circulates among Modes 1 to 4) — Off/On: Press Button to turn off/on Air PressureMusic— Press Button to select “Music”,then Press Button— Press Button to go to the next one (Preset Default – circulates among pre-recorded music) — Press Button to go to the previous one— Press and hold Button: Volume up— Press and hold Button: Volume down— Off/On: Press Button to turn off/on Music— Press and hold Button to switch over between built-in music and MP3 musicManualPower Charger Earphones BatteriesUSB CableOperationCharging of Main UnitOpen the cover of the DC power port on the main unit.Insert the plug of the power charger to the DC port.During charging, the light of the power charger is red. The light turns green when fully charged.1.2.3.OperationAutomatic Mode (without the remote control)1.2.Power ON – Push the ON/OFF switch on the main unit to Level “I” (Picture2)No need of remote control. The main unit starts working after 8 seconds. Preset default is air pressure + heat compression + music + 15 minutes duration. Power OFF – The main unit automatically shuts off after 15 minutes. Push the ON/OFF switch on the main unit to Level “O”.Power On/OffManual Mode (using the remote control）1.2.3.4.Power ON: Push the ON/OFF switch on the main unit to Level “I” (Picture2) The main unit is powered by a high performance, environment-friendly lithium battery.Press and hold Button on the remote control Preset default is air pressure + heat compression + music + 15 minutes durationDefault air pressure: Mode 5 – circulates among Modes 1 to 4;Default hot compress: low temperature;Default Music: Well-being music Power OFF: Press Button on the remote control. Push the ON/OFF switch on the main unit to Level “O”Power On/Off4.5.6.7.8.Take off contact lenses/eye glasses before use.Put on/wear the unit first BEFORE turning the power on.Do not use while walking or driving.Keep your eyes closed for a few seconds after use, then open them slowly.Keep the massager away from humidity, heat, and/or corrosive gas.This massager features heat compression. Individuals who are incapable of or do not ordinarily feel heat/cold sensation should use this device with caution. This device complies with Part 15 of the FCC Rules. Operation is subject to Please note that changes or modifications not expressly approved by the–Reorient or relocate the receiving antenna.–Increase the separation between the equipment and receiver.–Connect the equipment into an outlet on a circuit different fromthat to which the receiver is connected.–Consult the dealer or an experienced radio/TV technician for help the following two conditions: (1) this device may not cause harmful party responsible for compliance could void the user’s authority to operate the equipment.Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio ommunications. However, there is no guarantee that interference will not occur in a will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on,the user is encouraged to ry to correct the interference by one or more of the following measures: This equipment has been tested and found to comply with the limits for a interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.439

Navigation menu