Bulk Un 2106-2907 Digital Walkie Talkies User Manual

Bulk Unlimited Corp Digital Walkie Talkies

User manual

Download: Bulk Un 2106-2907 Digital Walkie Talkies User Manual
Mirror Download [FCC.gov]Bulk Un 2106-2907 Digital Walkie Talkies User Manual
Document ID4129349
Application IDIecXi2INLt8V4dkBlaXQ9g==
Document DescriptionUser manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize76.69kB (958665 bits)
Date Submitted2019-01-03 00:00:00
Date Available2019-01-03 00:00:00
Creation Date2018-12-27 15:34:00
Producing SoftwareAdobe Acrobat 15.7 Image Conversion Plug-in
Document Lastmod2018-12-27 15:34:13
Document TitleUser manual
Document CreatorAdobe Acrobat 15.7

280x210mm
* Only adults should replace the batteries.
* Do not mix battery types or old and new batteries together.
* Remove exhausted batteries from walkie talkies.
* The supply terminals are not to be short circuited.
* Packaging should be kept as it may contain important information.
* All packaging to be removed before giving to child.
NOTE: The working range for these walkie talkies
are 2 miles. They work best in open areas however
the weather and environment can also effect the
range.
Warning: Changes or modifications to this equipment not expressly approved by the party responsible for
compliance could void the user‘s authorty to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital devics,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not instaled and used in accordance with the instructions, may cause harmful
interference to radio communications.
However there is no guarantee that interference willnot occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver
* Comnect the equipment into an outlet on a circuit different from that to which the receiver is connected.
* Consult the dealer or an experienced radio/TV technician for help
For body worn operation, this handset has been tested and meets the FGC RF exposure guidelines when
used with the accessories supplied or designated forthis product.Use of other accessories may not ensure
compliance with FCC RF exposure guidelines.
Frontofface : 0.032Wkg
Body—worn : 0.072Wikg
BROOKLYN, NY 11205
www nesstoy.com
© 2018 NESSTOY
Manufactured and
Imported by
orenation |
Color LED
Indicator
Indicator
LED Rashlight
LCD Display > mfin (é.hla)ngsr
Push to Talk:
Rashlight
Microphone
Belt Clip
To power on press the On/Off Button. The Walkie Talkies switch on
automatically when the batteries are installed. The walkie talkie will beep and
the display will show the current channel number. Press and hold the Voice
Changer button to ring other walkie talkies. Press the Voice Changer button to
disguise your voice, press it again to make your voice go back to normal. To
speak press the Talk Button. Hold the walkie talkie approximately 1.5 — 2
inches from your mouth and speak at a normal volume. Speaking to loud will
cause distortion. Release Talk Button after speaking. To change channels
press the Channel Selector Button for 2 — 3 seconds. The Channel Indicator
will display the selected channel.
ARMOGEAR @
Owner‘s Manual
Item # KL—2106
FOC ID: 2AE67—2106—2007
This is device complies with Part 15 of the FOC Rules.
Operation is subject o the folowing two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including Interference that may cause undesired operation.
Belt Clip Locking
Release Clip
(3) AAA Batteries
Per Walkie Talkie
Battery Door
Screw Location
To install the batteries release the belt clip locking clip and slide the belt clip
vertically off the back of the walkie talkie body. Remove the battery
compartment screw and lift the battery door off. Insert (3) AAA batteries as
shown in illustration. Replace battery door and secure with screw. Replace
belt clip and ensure it‘s secure.
uiesns
If you are not receiving a message: make sure both walkie talkies are
switched on and the your not holding the Talk Button while waiting for a
message to be heard. If this doesn‘t work check the batteries. They must be
properly installed and in good working order.
If a message is fading or you hear interference: make sure the antenna is
pointing up. Don‘t get to close to buildings or large structures. Power lines can
also cause interference. Move closer if your out of range. Keep the walkie
talkie 1.5 — 2 inches from your mouth and speak in at a normal volume.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Create Date                     : 2018:12:27 15:34:00+08:00
Creator                         : Adobe Acrobat 15.7
Modify Date                     : 2018:12:27 15:34:13+08:00
XMP Toolkit                     : Adobe XMP Core 5.6-c015 81.157285, 2014/12/12-00:43:15
Metadata Date                   : 2018:12:27 15:34:13+08:00
Creator Tool                    : Adobe Acrobat 15.7
Format                          : application/pdf
Document ID                     : uuid:04c0ee3f-04ee-4ef8-a95a-abbf62ece6e7
Instance ID                     : uuid:9231cd54-06f6-429e-bb40-5e4baa87939b
Producer                        : Adobe Acrobat 15.7 Image Conversion Plug-in
Page Count                      : 1
EXIF Metadata provided by EXIF.tools
FCC ID Filing: 2AE67-2106-2907

Navigation menu