CHINA ELECTRONICS B102 BLUETOOTH SPEAKER User Manual
China Electronics Shenzhen Company BLUETOOTH SPEAKER
User Manual
B102
USER MANUAL
Product Specification:
Main parameter:
Bluetooth version: V4.1
output power：3W
frequency response：150hz-18khz
RMS：（ THD = 10%）
drive：2’
power supply：USB, DC 5V 500mA
distortion：≦1%
S / N：≥ 75dB
Charging the Speaker:
Before using the speaker for the first time, charging it for at least 0.5 hours.
1、Plug the USB cable into the port on the speaker, plug the other end into the USB port on the
adapter(DC 5V).
2、Red LED will turn on to indicate that the unit is charging.
3、Red LED will turn off when fully charged.
Start-up& Shutdown Functions:
1、Long press POWER to start the blue-tooth speaker.
2、Blue LED g flashes, waiting for pairing
3、Long press POWER to shutdown the blue-tooth speaker.
4、LED off if shutdown the speaker.
Pairing the Device:
1、Place the speaker near the Blue-tooth-enabled device.
2、Long press POWER to start the blue-tooth speaker, blue LED flashes, the speaker is now in
pairing mode.Follow the instructions of your device to search for the speaker.
2、The speaker is called “B102”, enter the PIN”0000” if need.
3、Blue LED light, the completion of the pairing, while the voice prompts. The speaker is in the
state of pairing the last device default in the first 3 seconds after starting. If failing to pair, the
speaker will be in state of pairing automatically.
LED Indicator
1、Charging: Red LED on
2、Fully charged: Red LED off
3、Pairing Mode: Blue LED flashes.
4、Connected: Blue LED slow flashes
5、Line IN Mode: Blue LED on
6、Low battry: Red LED flashes
FCC Warning Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer
could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement. The device can be used
in portable exposure condition without restriction.