Cadi Scientific SMN890 SMART NODE RECEIVER 890 User Manual SMN 890 SmartNODE User Guide

Cadi Scientific Pte. Ltd. SMART NODE RECEIVER 890 SMN 890 SmartNODE User Guide

user manual

Download: Cadi Scientific SMN890 SMART NODE RECEIVER 890 User Manual SMN 890 SmartNODE User Guide
Mirror Download [FCC.gov]Cadi Scientific SMN890 SMART NODE RECEIVER 890 User Manual SMN 890 SmartNODE User Guide
Document ID1235752
Application IDKZBVA2eYoTZoI/LjB3513g==
Document Descriptionuser manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize32.64kB (408061 bits)
Date Submitted2010-02-02 00:00:00
Date Available2010-02-04 00:00:00
Creation Date2010-01-14 15:07:58
Producing SoftwareNitro PDF PrimoPDF
Document Lastmod2010-01-25 16:35:11
Document TitleMicrosoft Word - SMN-890 SmartNODE User Guide.doc
Document CreatorPrimoPDF http://www.primopdf.com
Document Author: konsang

SM-890 SmartODETM
RFID Receiver and IR Location Beacon
User Guide
Cadi Scientific Pte Ltd
Cadi Scientific Pte Ltd
Federal Communications Commission (FCC) Statement
15.21
You are cautioned that changes or modifications not expressly approved by the part
responsible for compliance could void the user’s authority to operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that may cause undesired
operation of the device.
COPYRIGHT
Specifications are subject to change without notice. Copyright © 2003 Cadi Scientific Pte Ltd.
All rights reserved.
Cadi Scientific Pte Ltd
31, UBI ROAD 1
#03-00
AZTECH BUILDING
Singapore 408694
Singapore
http://www.cadi.com.sg
Cadi Scientific Pte Ltd
Introduction
The SMN-890 SmartNODETM RFID Receiver is an integral component of the
SmartSense Wireless Vital Signs and Location Tracking System. The system is
designed for wireless and automated measurement and recording of patient vital
signs and for location tracking of patients and high-value assets.
The SMN-890 will periodically transmit IR and LF beacon signal. This beacon
signal consists of unique location ID. This location will be received by tag which
are in range. IR and LF signal are very localized which give better location
tracking determination.
The SMN-890 SmartNODETM RFID Receiver is a LAN-enabled receiver for
receiving data transmitted by the SmartSenseTM series of wireless sensors and
monitors.
The receiver uploads data received from the sensors to the
SmartSenseTM database via its built in Ethernet LAN interface.
In a typical installation, the receivers are to be installed at strategic locations in the
hospital in a manner to meet the specific coverage requirement of the application.
The receivers being Ethernet LAN capable lend themselves well to deployment
using standard Ethernet LAN equipment and infrastructure.
Cadi Scientific Pte Ltd
Typical System Setup
The following diagram shows how SMN-800/900 is deployed in a typical
SmartSense System configuration.
AC Outlet
Ethernet
Power
Ethernet
Server
etwork Switch
22
21
1A
20
18
16
15
0F
10
11
14
0B
0C
0D
0E
09
COMMAND
01
VALUES
00
01
S1 
S2 
S3 
S4 



00
01
Source Exif Data: 
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
XMP Toolkit                     : 3.1-701
Create Date                     : 2010:01:14 15:07:58-08:00
Creator Tool                    : PrimoPDF http://www.primopdf.com
Modify Date                     : 2010:01:25 16:35:11+08:00
Metadata Date                   : 2010:01:25 16:35:11+08:00
Format                          : application/pdf
Creator                         : konsang
Title                           : Microsoft Word - SMN-890 SmartNODE User Guide.doc
Producer                        : Nitro PDF PrimoPDF
Document ID                     : uuid:c26a990c-a12d-47d4-abe6-4865969af144
Instance ID                     : uuid:4464f34a-e420-4f67-b966-25210b489c59
Page Count                      : 9
Author                          : konsang
EXIF Metadata provided by EXIF.tools
FCC ID Filing: VPE-SMN890

Navigation menu