Cambium Networks 89FT0036 cnPilot E600 Indoor User Manual QSG
Cambium Networks Inc. cnPilot E600 Indoor QSG
Contents
- 1. User Manual
- 2. QSG User Manual
QSG User Manual
| Download: |  |
| Mirror Download [FCC.gov] | |
| Document ID | 3886642 |
| Application ID | u8hUG7aO0+a4dDRVcFeDiQ== |
| Document Description | QSG User Manual |
| Short Term Confidential | No |
| Permanent Confidential | No |
| Supercede | No |
| Document Type | User Manual |
| Display Format | Adobe Acrobat PDF - pdf |
| Filesize | 90.72kB (1134050 bits) |
| Date Submitted | 2018-06-13 00:00:00 |
| Date Available | 2018-08-06 00:00:00 |
| Creation Date | 2018-06-11 09:42:23 |
| Producing Software | TurboPDF Printer Version 9.0.1.1109 |
| Document Lastmod | 2018-06-12 15:52:59 |
| Document Title | QSG User Manual |
TM Cambium Networks cnPilotM e600 The guide provides a quick installation process. 802.11ac Wave2 Indoor Access Point Package Contents Quick Start Guide 38 mm T - Bar Rail Mounting Ceiling Tile Mounting Product Overview Introduction Mounting Plate Cable Route Hole e600 Access Point Multi color LED Wall Mounting Kit Ceiling Mounting Screws (Qty 4) Mounting Plate Mounting Bracket Top View 4r Screws x 4 Desk Mount Foot Rubber Foot T bar Mount Holder . 2) Mounting Bracket Ceiling Tile Ceiling Mounting Bracket (Qty 38mm wide T bar rail (Qty 4) Wall Mount Anchor Ceiling Tile POE Injector * 12 V DC Power Power Cord * USB Port Jack Tools Required Lock Slot The e 600 mounts to a ceiling tile and allows for the ethernet cable to be hidden by routing through a hole in Reset Button ETHI/PoE IN • Philips Screwdriver ETH2 The e 600 is secured to a 38mm ceiling T -bar rail by using the ceiling mount bracket the ceiling tile Bottom View Model: e 600 Exploded View Kensington Removable Clip x 2 Only available for certain ordering SKUs 24mm T - Bar Rail Mounting 14mm T - Bar Rail Mounting Wall Mounting Rubber feet Assembly The e600 can be mounted on any surface by attaching the rubber feet to the underside of the unit. 24mm wide T bar rail 14mm wide Cambium Networks Community Forum T bar rail raJ Ceiling Tile JOIN THE CONVERSATION community.cambiumnetworks.com The e 600 can be mounted to a 24mm width T-bar rail The e600 can be mounted to a 14mm width T-bar rail The e 600 mounts to any wall by using two screws with using the clips built into the underside of the unit using the clips built into the underside of the unit corresponding wall anchors Powering Up 1. Connect the Ethernet cable from Ethl/PoE-IN of e600 to the PoE port of Gigabit Data + Power 2. Connect an Ethernet cable from your LAN or Computer to the Select Properties for the Ethernet port. In Windows it is found in The cnPilot e 600 Access Point supports multiple modes of Control Panel > Network and Internet > Network Connections > Local Area Connection. management : I » Standalone: The Access Point can be managed directly from its GUI by selecting the ‘Configure’ tab on the menu, and setting up a wireless LAN — -- * *4 4*«»•« » -H Controller : The Access Point can be onboarded to cnMaestro network controller system, either on-premises or the cloud version at IP Address Configuration ETH 2 the ‘Troubleshooting’ tab of the Access Point GUI Connection status can LED Color Amber Blue Green Status Access Point is Access Point is Indicator powering up in service Power LED should illuminate continuously on PoE Adapter S6 V/ 40 W Gigabit Passive Pot injector . BO? .Sat PSL . 802.3af (Reduced Functionality ), 12Vdc Power Adapter Dual Polarized Single and Dual Band Internal Antennas 802 lla/b/g/n/ac Wave 2 Bluetooth Standard WPA 2 Pre shared Keys WPA2 Enterprise Wireless Client Connectivity. Mesh Mounting Operating Humidity Certification Wireless Security The equipment requires the use of the ground wire as a part of the safety certification, modification or misuse can provide a shock hazard that can result in serious injury or death V40 Operating Modes Do not substitute the power cord with one that is not the provided approved type Never use an adapter plug to connect to a 2 wire outlet as this will defeat the continuity of the grounding wire Celling tile I- bar Desktop Wall O* to 50* C 5 - 95% Noncondensing CF. FCC. 1C 4. Contact a qualified electrician or the manufacturer if there are questions about the installation prior to connecting the equipment Protective earthing is provided by Listed AC adapter Building installation shall provide appropriate short circuit backup protection Protective bonding must be installed in accordance with local national wiring rules and regulations Be aware that the unit surfaces can become very hot to the touch so do not handle the device when it is running for long periods of time Turn off power to the device first for a few minutes and then handle the unit carefully This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications However, there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio/TV technician for help For indoor use only IMPORTANT NOTE: 1C Radiation Exposure Statement: This equipment complies with 1C RSS 102 radiation exposure limits set forth for an uncontrolled environment This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body Cet equipement est conforme aux limites d’exposition aux rayonnements 1C etablies pour un environnement non controle Cet equipement doit etre installe et utilise avec un minimum de 20 cm de distance entre la source de rayonnement et votre corps CE Marking CE marking on this product represents the product is in compliance with all directives that are applicable to it This radio transmitter has been approved by ISED with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device Online Resources Antenna Information: Two dual band and three single band antenna, Gain 6.11/6.17 dBi1C User Guide and software downloads: https://support cambiumnetworks com/ files/e600/ Statement : This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device. L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : conditions Wi-Fi 2.4 /5G 24 dBm/ 28dBm; Bluetooth * 4dBm two This equipment is provided with a detachable power cord which has an integral safety ground wire intended for connection to a grounded safety outlet following 3. the cB to « subject is Operation . >- . Ant lJ 4G 1 lldli i M M.I M 22.SW (12.9SW 80? ial mode) For indoor use only Pour une utilisation en interieur uniquement RSS(s). licence-exempt * IIM' There are no serviceable parts inside this equipment Service should be provided only by a qualified service technician Canada’s 2. Development IbMocAi J T dOi i SO ! «::B Economic Am t 140 4 Mdli The device for operation in the band 5150 5250 MHz is only for indoor use to reduce the potential for harmful interference to co channel mobile satellite systems, les dispositifs fonctionnant dans la bande 5150 5250 MHz sont reserves uniquement pour une utilisation a I’interieur afin de reduire les risques de brouillage prejudiciable aux systemes de satellites mobiles utilisant les memes canaux and For product available in the USA /Canada market, only channel 1 11 can be operated Selection of other channels is not possible This device is restricted for indoor use IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment This equipment should be installed and operated with minimum distance 24 cm between the radiator & your body Caring for the Environment: RoHS/ WEEE European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its packaging must not be disposed of with unsorted municipal waste The symbol indicates that this product should be disposed of separately from regular household waste streams It is your responsibility to dispose of this and other electric and electronic equipment via designated collection facilities appointed by the government or local authorities Correct disposal and recycling will help prevent potential negative consequences to the environment and human health For more detailed information about the disposal of your old equipment, please contact your local authorities, waste disposal service, or the shop where you purchased the product Science An! Innovation, Version 2.0 Host Compliance with manufacturer ’s label for voltage, frequency, and current requirements Connecting to a different power source than those specified may result in improper operation, damage to equipment or pose a fire hazard if the limitations are not followed For product available in the USA /Canada market, only channel 1-11 can be operated Selection of other channels is not possible Pour les produits disponibles aux Etats-Unis / Canada du marche, seul le canal 1 a 11 peuvent etre exploites Selection d'autres canaux n'est pas possible with comply USB Port Operating Tomperaturo Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions This device may not cause harmful interference, and 2 This device must accept any interference received, including interference that may cause undesired operation that 2 X RJ4510/100/1000 Mbps Ethernet Networking Interface Wifi Standards To prevent loss of life or physical injury, observe the following safety guidelines In no event shall Cambium Networks be liable for any injury or damage caused during the installation of e600 platform Ensure that only qualified personnel install , Only use attachments/accessories specified by the manufacturer RoHS/ WEEE Compliance ISED Compliance transmitter(s)/receiver(s) 2412 - 2462MHz 5180 - 5850MHz 2402 - 2480MHz 2.4GHZ 5GHz Bluetooth Antenna FCC Compliance Electrical Safety Information Operating Frequency Power Supply The Main port is a Gigabit Ethernet port used to connect the power and should be connected to the LAN and DHCP server licence-exempt 0.4 kg 0 88 tbs Product Weight Max 1 X Power Management Protocols enabled by default -http or https ( webpage contains Product Dimensions To restore to factory default settings, press and hold the Warning: 180 * 180 x 42 mm 7.1 x 7.1 x 16 inch To restart, press and release the Reset button quickly Reset button for more than 10 seconds Safety Notice LAN Port Modal: 600 Antenna Gain Password: admin management interface access), SSH ( CLI management interface access) Specifications Max Power Consumption device — The Reset button serves two functions for e600: autopilot This Once powered ON Reset cnMaestro or Default Login information Username: admin Access Point is managed with and Intitializing Bottom View be monitored from the AP dashboard »•9 Lock Slot Reset Button ETH1/PoE IN Kensington the internet Connectivity can be verified using tools such as ping from mum Cord into a power outlet USB Port Jack For management from cloud please ensure the AP has connectivity to there is no DHCP server Connect the Power Cord to the adapter, and then plug the Power 12 V DC Power Removable Clip x2 cn Pilot e 600 will use a default static IP address of 192.168 0.1, If https://cloud cambiumnetworks com Default IP address received via DHCP. Hardware Overview uui nti Gigabit Data port of the PoE adapter Hardware Overview AP Management Configure Management PC 1. L’appareil ne doit pas produire de brouillage; 2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. Support: http:// www cambiumnetworks com/ support/ http:// www cambiumnetworks com support/contact support/
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.7 Linearized : No Has XFA : No Page Count : 2 XMP Toolkit : Adobe XMP Core 5.6-c015 84.159810, 2016/09/10-02:41:30 Format : application/pdf Creator : Description : Title : Create Date : 2018:06:11 09:42:23+08:00 Creator Tool : Modify Date : 2018:06:12 15:52:59+08:00 Metadata Date : 2018:06:12 15:04:28+08:00 Keywords : Producer : TurboPDF Printer Version 9.0.1.1109 Document ID : uuid:b9fedc36-6463-41b8-a505-a37ea75865d9 Instance ID : uuid:1c026c2c-bbf7-421d-87ba-dfe2fd7f02b2 Author : Subject :EXIF Metadata provided by EXIF.tools