Chamberlain Group The 1666 Remote Control Transmitter User Manual 01 17928 REV E Page 1

Chamberlain Group Inc, The Remote Control Transmitter 01 17928 REV E Page 1

Exhibit D Users Manual per 2 1033 b3

Children operating or playing with a garage dooropener can injure themselves or others. The garagedoor could close and cause serious injury or death. Donot allow children to operate the wall push buttons orremote controls.A moving garage door could injure or kill someoneunder it. Activate the opener only when you can seethe door clearly, it is free of obstructions, and isproperly adjusted.WARNINGCAUTIONWARNINGWARNINGModel CPTxRemote ControlOWNER'S MANUALPASSPORT™NOTICE: To comply with FCC rules, adjustment or modifications of thisreceiver and/or transmitter are prohibited, except for changing the codesetting or replacing the battery. THERE ARE NO OTHER USERSERVICEABLE PARTS.NOTE: The Passport transmitter works with all ChamberlainSecurity+TM rolling code garage door openers.NOTE: When using the Passport transmitter with an accesssystem or gated entry, contact property manager.NOTE: If programming a HomeLink Rtransmitter for anaccess system is required, contact property manager.PROGRAMMINGLOCKLIGHT1. Press and hold the button on the hand-held remote*that you wish to operateyour garage door.2. While holding the remote button, pressand hold the LIGHT button on the Multi-Function Door Control.3. Continue holding both buttons while youpress the push bar on the Multi-FunctionDoor Control (all three buttons are held).4. Release buttons when the motor unitlights blink. It has learned the code. Iflight bulbs are not installed, two clicks willbe heard.KG13975KG13975231KG KGOR1. Press and release the “learn” button onthe motor unit. The learn indicator lightwill glow steadily for 30 seconds.2. Within 30 seconds, press and hold thebutton on the hand-held remote*that youwish to operate your garage door.3. Release the button when the motor unitlights blink. It has learned the code. Iflight bulbs are not installed, two clicks willbe heard.USING THE “LEARN” BUTTON231KGKGLOCKLIGHTLOCKLIGHTUSING THE MULTI-FUNCTION DOOR CONTROLTo Erase All Codes From Motor Unit MemoryTo deactivate any unwanted remote, firsterase all codes:Press and the hold “learn” button on motorunit until the learn indicator light goes out(approximately 6 seconds). All previouscodes are now erased. Reprogram eachremote or keyless entry you wish to use.231KG KGNOTE: Any button can be used with a garage door openerand/or access control system.Notice that on a four-button remote,the fourth button has a differentaccess control identification numberand facility code than the otherthree buttons. This only affects howthe access control system isprogrammed by the propertymanager.1423GARAGE DOOROPENERACCESS SYSTEMOR GARAGEDOOR OPENERS
The Remote Control Batteries1. The lithium batteries should produce power for up to5 years.2. To replace, pry open case with visor clip or screwdriver, asshown. Insert batteries positive side up (+). See figure 4.3. Dispose of old batteries properly.WARNINGCAUTIONWARNINGWARNINGKeep batteries away from small children. Ifswallowed, promptly notify doctor.© 2002, The Chamberlain Group Inc.114A2688A All Rights Reserved Printed in MexicoFigure 4CPT1 (SINGLE CHANNEL TRANSMITTER) CPT2 (DUAL CHANNEL TRANSMITTER)CPT3 (THREE CHANNEL TRANSMITTER) CPT4 (FOUR CHANNEL TRANSMITTER)

Navigation menu