Chamberlain Group The 1666 Remote Control Transmitter User Manual 01 17928 REV E Page 1

Download:
Mirror Download [FCC.gov]
Document ID	544089
Application ID	1HS+NcG0rcZabRva4R3mzA==
Document Description	Exhibit D Users Manual per 2 1033 b3
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	65.84kB (822950 bits)
Date Submitted	2005-05-20 00:00:00
Date Available	2005-05-20 00:00:00
Creation Date	2002-07-29 18:57:43
Producing Software	Acrobat Distiller 5.0.5 (Windows)
Document Lastmod	2002-09-03 14:43:50
Document Title	01-17928 REV E.qxd (Page 1)
Document Creator	QuarkXPress(R) for Windows 4.0

Model CPTx
Remote Control
™
OR T
PA S
OWNER'S MANUAL
NOTICE: To comply with FCC rules, adjustment or modifications of this
receiver and/or transmitter are prohibited, except for changing the code
setting or replacing the battery. THERE ARE NO OTHER USER
SERVICEABLE PARTS.
WARNING
Children operating or playing with a garage door
opener can injure themselves or others. The garage
door could close and cause serious injury or death. Do
not allow children to operate the wall push buttons or
remote controls.
A moving garage door could injure or kill someone
under it. Activate the opener only when you can see
the door clearly, it is free of obstructions, and is
properly adjusted.
NOTE: The Passport transmitter works with all Chamberlain
Security+TM rolling code garage door openers.
NOTE: When using the Passport transmitter with an access
system or gated entry, contact property manager.
CAUTION
NOTE: If programming a HomeLink R transmitter for an
access system is required, contact property manager.
PROGRAMMING
USING THE “LEARN” BUTTON
KG
USING THE MULTI-FUNCTION DOOR CONTROL
KG
LOCK
LIGHT
OR
KG
1. Press and release the “learn” button on
the motor unit. The learn indicator light
will glow steadily for 30 seconds.
1. Press and hold the button on the handheld remote* that you wish to operate
your garage door.
KG
KG
2. While holding the remote button, press
and hold the LIGHT button on the MultiFunction Door Control.
2. Within 30 seconds, press and hold the
button on the hand-held remote* that you
wish to operate your garage door.
LOCK
LIGHT
3. Continue holding both buttons while you
press the push bar on the Multi-Function
Door Control (all three buttons are held).
3. Release the button when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks will
be heard.
LOCK
LIGHT
4. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks will
be heard.
To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, first
erase all codes:
Press and the hold “learn” button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each
remote or keyless entry you wish to use.
KG
KG
KG
NOTE: Any button can be used with a garage door opener
and/or access control system.
Notice that on a four-button remote,
the fourth button has a different
access control identification number
and facility code than the other
three buttons. This only affects how
the access control system is
programmed by the property
manager.
GARAGE DOOR
OPENER
ACCESS SYSTEM
OR GARAGE
DOOR OPENERS
The Remote Control Batteries
1. The lithium batteries should produce power for up to
5 years.
2. To replace, pry open case with visor clip or screwdriver, as
shown. Insert batteries positive side up (+). See figure 4.
3. Dispose of old batteries properly.
WARNING
Keep batteries away from small children. If
swallowed, promptly notify doctor.
CAUTION
Figure 4
CPT1 (SINGLE CHANNEL TRANSMITTER)
CPT2 (DUAL CHANNEL TRANSMITTER)
CPT3 (THREE CHANNEL TRANSMITTER)
CPT4 (FOUR CHANNEL TRANSMITTER)
114A2688A
© 2002, The Chamberlain Group Inc.
All Rights Reserved
Printed in Mexico

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Create Date                     : 2002:07:29 18:57:43Z
Modify Date                     : 2002:09:03 14:43:50-05:00
Creator                         : QuarkXPress(R) for Windows 4.0
Page Count                      : 2
Creation Date                   : 2002:07:29 18:57:43Z
Mod Date                        : 2002:07:29 14:59:04-04:00
Producer                        : Acrobat Distiller 5.0.5 (Windows)
Metadata Date                   : 2002:07:29 14:59:04-04:00
Title                           : 01-17928 REV E.qxd (Page 1)

EXIF Metadata provided by EXIF.tools